Onkyo HT-S7300 Connecting the AV Receiver, Attaching the Speaker Bases, Wall Mounting, SKF-780

Models: HT-S7300

1 76
Download 76 pages 43.83 Kb
Page 14
Image 14
Connecting the AV Receiver

Connecting the AV Receiver

Attaching the Speaker Bases

SKF-780

Before you connect the speakers, attach the supplied speaker base to each SKF-780.

1.Turn the speaker upside down with the protection cover attached.

2.Align the speaker base while the arrow mark Attaching the Speaker Bases is headed in the same direction as the speaker’s face. Be careful not to tip over the speaker.

3.Align the screw holes on the speaker base with those on the bottom of each speaker, and affix the speaker base using the supplied screws. Recommended torque is 10 kgf·cm (9 lbf·in).

Be careful not to tip over the speaker.

4.Turn the speaker right side up.

5.Remove the protection cover.

Top of SKF-780

Protection cover

Wall Mounting

The speakers can easily be wall mounted by using the key- hole slots.

Front, Surround and Surround Back Speakers

To mount the front, surround and surround back speakers vertically, use the keyhole slot shown to hang each speaker on a screw that’s securely screwed into the wall.

SKF-680, SKR-680, SKB-680

To prevent the speaker from vibrating against the wall, attach two of the supplied rubber stoppers to the rear of each speaker.

■SKF-780 Supplied screws

Arrow mark

Speaker base

Wall Mounting Bottom of SKF-780

Rubber stoppers Front, Surround and Surround Back Speakers

SKR-780,SKB-780

Keyhole slot for wall mounting

Keyhole slot for wall mounting

SAFETY PRECAUTIONS:

Attach the speaker bases in a manner that will not allow the speakers to tip over.

Be sure to tighten the screws when you attach the speaker bases.

Attach the speaker bases on a flat, level, and stable floor.

After you attach the speaker bases, make sure that the speakers stand upright and are stable.

Center Speaker

To mount the center speaker horizontally, use the two key- hole slots shown to hang each speaker on two screws that are securely screwed into the wall.

SKC-680

To prevent the speaker from vibrating against the wall, attach two of the supplied rubber stoppers to the rear of each speaker.

Keyhole slot for wall mounting

Rubber ■SKF-680, SKR-680, SKB-680 stoppers

8-1/4" (210 mm)

En

14

Page 14
Image 14
Onkyo HT-S7300 Connecting the AV Receiver, Attaching the Speaker Bases, Wall Mounting, Center Speaker, SKF-780, SKC-680