Using the Onkyo Dock
For the latest information on the Onkyo Dock compo- nents, see the Onkyo web site at: http://www.onkyo.com
Before using the Onkyo Dock components, update your iPod with the latest software, available from the Apple web site.
UP-A1 Dock
With the supplied
You can use the AV receiver’s remote controller to operate your iPod.
■Compatible iPod models
Made for:
• iPod touch (1st and 2nd generation)
• iPod classic
• iPod (4th and 5th generation)
• iPod nano (1st, 2nd, 3rd, 4th and 5th generation)
• iPod mini
• All iPhone models
■Putting Your iPod in the Dock
1.Turn on the AV receiver, and select the PORT selector.
2.Align your iPod with the Dock connec-
tor, and carefully place your iPod in the slot, as shown.
Note
•Remove the case, if fitted, from your iPod before inserting it into the
■Adjusting the Adapter
The adapter needs to be adjusted to match your particular iPod. If there’s a gap between the back of your iPod and the adapter, turn the adapter counterclockwise to close the gap. Turning the adapter counterclockwise moves it for- ward. Turning it clockwise moves it backward.
Forward
Backward
Note
•Make sure that the output level of the AV receiver is set to mini- mum.
•To prevent damage to the dock connector, don’t twist your iPod when inserting or removing it, and be careful not to knock over the dock while your iPod is inserted.
•Do not take off your iPod from the Dock when you play back the music, photo, or movie stored on your iPod.
•Don’t use the
•It is recommended that you update your iPod software before using it with this unit. The updater for the iPod software is avail- able at the Apple website.
■Basic Operation
The AV receiver may take several seconds to startup, so you might not hear the first few seconds of the first song.
Auto Power On
If you start iPod playback while the AV receiver is on Standby, the AV receiver will automatically turn on and select your iPod as the input source.
Direct Change
If you start iPod playback while listening to another input source, the AV receiver will automatically select your iPod as the input source.
Using the AV receiver’s Remote Controller
You can use the AV receiver’s remote controller to control basic iPod functions (➔ 58).
■Operating Notes
•Functionality depends on your iPod model and generation.
•Before selecting a different input source, stop iPod playback to prevent the AV receiver from selecting the iPod input source by mistake.
•If any accessories are connected to your iPod, the AV receiver may not be able to select the input source properly.
•When connecting
•While your iPod is in the
•The Auto Power On function will not work if you set your iPod in the
•When Zone 2 is turned on, you can’t use Auto Power On and Direct Change functions.
■Using Your iPod models Alarm Clock
You can use your iPod models Alarm Clock function to automatically turn on your iPod and the AV receiver at a specified time. The AV receiver’s input source will auto- matically be set to the PORT selector.
Note
•To use this function, your iPod must be in the
•This function only works when the Standard mode is set to On.
•When you use this function, be sure to set the AV receiver’s vol- ume control to a suitable level.
•When Zone 2 is turned on, you can’t use this function.
•You cannot use this function for sound effects on your iPod.
En
57
