Onkyo HT-SR800 Connecting Components with HDMI, Connecting Your Components-Continued

HT-SR800_En.book Page 29 Thursday, January 25, 2007 10:28 AM

Connecting Your Components—Continued

Connecting Components with HDMI

If you have an HDMI-compatible player, you can connect it to the AV receiver with an HDMI cable.

Step 1: Connect your HDMI-compatible TV to the AV receiver’s HDMI OUT jack.

Step 2: Connect your HDMI-compatible player to the AV receiver’s HDMI IN 1 or 2 jack.

Step 3: Connect your HDMI-compatible player to an analog and/or digital audio input on the AV receiver.

✽Audio and video signals received via the HDMI IN 1 and 2 jacks are output by the HDMI OUT jack as they are (HDMI pass-through), so even if you only make the connections in steps 1 and 2, your TV will output sound. However, if you want to listen through the speakers connected to the AV receiver, in addition to an

HDMI connection, you’ll also need to make a separate analog or digital audio connection.

Step 4: Assign the HDMI IN.

Turn on the AV receiver, and then assign the HDMI IN (see page 40)

DVD player

Step 3 ✽

Connect one or the other

		HDMI				HDMI
		OUT				IN
											TV
				Step 2			Step 1
			HDMI				HDMI
			ASSIGNABLE
				IN 1
											Tip!
				HDMI							If you make the connection described in
	IN 2	IN 1			ANTENNA						step 3, to fully enjoy the AV receiver's lis-
				OUT ASSIGNABLE					SURROUND BACK
				AM		FM 75
									SPEAKERS
DIGITAL IN									L		tening modes, turn down the volume on
ASSIGNABLE			Y
IAL1
COAX-
(DVD)								MONITOR			your TV all the way so that its speakers
				CBL/SAT	VCR/DVR		DVD
								OUT	V
2			CB/PB	V					R		output no sound.
(CBL/SAT)
OPTICAL									S
1			CR/PR	S
(VCR/DVR)
	CBL/SAT IN VCR/DVR IN DVD IN		OUT	IN	OUT	IN	IN
	COMPONENT VIDEO
2
	IN	OUT	IN	IN	OUT	IN	FRONT SURROUND CENTER			SURR BACK
(CD)
	L		L	L						L
	R		R	R						R	Sound off
REMOTE									SUB
CONTROL	CD	TAPE		CBL/SAT	VCR/DVR			DVD	WOOFER

Notes:

•Audio and video signals received via the HDMI IN jacks are output only by the HDMI OUT.

•Audio and video signals received via inputs other than the HDMI IN jacks are not output by the HDMI OUT.

•The HDMI video stream is compatible with DVI (Digital Visual Interface), so TVs and displays with a DVI input can be connected by using an HDMI-to-DVI adapter cable. (Note that DVI connections only carry video, so you’ll need to make a separate connection for audio.) However, reliable operation with such an adapter is not guaranteed. In addition, video signals from a PC are not supported.

•To watch an HDMI source that’s connected via the AV receiver’s HDMI jacks, the AV receiver must be turned on, otherwise no HDMI signal will be output.

•The HDMI audio signal (sampling rate, bit length, etc.) may be restricted by the connected source component. If the picture is poor or there’s no sound from a component connected via HDMI, check its setup. Refer to the connected component’s instruction manual for details.

29