Onkyo HT-SR800 instruction manual Advanced Setup, Advanced Speaker Settings, Speaker Configuration

Cone diameter

HT-SR800_En.book Page 56 Thursday, January 25, 2007 10:28 AM

Advanced Setup

Advanced Speaker Settings

This section explains how to check the speaker settings and how to set them manually, which is useful if you change a speaker after performing the automatic speaker setup.

Some speaker settings are set automatically by the Auto- matic Speaker Setup function (see page 37).

Speaker Configuration

These settings are set automatically by the Automatic Speaker Setup function (see page 37).

This section explains how to specify which speakers are connected and their sizes.

For speakers with a cone diameter

larger than 6-1/2 inches (16 cm), specify Large (full band). For those

with a smaller diameter, specify

Small (default crossover 100 Hz). The crossover frequency can be

changed on page 57.

1	Press the [RECEIVER] button fol-
RECEIVER	lowed by the [SETUP] button.

	SETUP
2	Use the Up and Down [ ]/[ ]

buttons to select “Sp Config,” and then press the [ENTER] but- ton.

3	While the Subwoofer setting is
	selected, use the Left and Right
	[ ]/[ ] buttons to select Yes or
	No.
	Yes: Select if a subwoofer is con-
	nected.
	No: Select if no subwoofer is con-
	nected.

4

5

6

Use the Down [ ] button to select “Front,” and then use the Left and Right []/[ ] buttons to

select Small or Large.

Small: Select if the front speakers are small.

Large: Select if the front speakers are large.

Note:

• If the Subwoofer setting in step 3 is set to No, this setting is fixed at Large and does not appear.

Use the Down [ ] button to select “Center,” and then use the Left and Right []/[ ] buttons to

select Small, Large, or None.

Small: Select if the center speaker is small.

Large: Select if the center speaker is large.

None: Select if no center speaker is connected.

Note:

•If the Front setting in step 4 is set to Small, the Large option cannot be selected.

Use the Down [ ] button to select “Surround,” and then use the Left and Right []/[ ] but- tons to select Small, Large, or None.

Small: Select if the surround speak- ers are small.

Large: Select if the surround speak- ers are large.

None: Select if no surround speakers are connected.

Note:

•If the Front setting in step 4 is set to Small, the Large option cannot be selected.

56