Onkyo HTP-750 Getting to know Your Speaker Package, Speaker Stand, Keyhole slots

Getting to know Your Speaker Package

Front, Center, Surround, and Surround back speakers (SKF-750XF, SKC-750XC, SKM-750XS, SKB-750X)

Rear

1

3

2

AKeyhole slots

These keyhole slots can be used to wall-mount the speaker.

They can also be used to install the speaker on the stand.

BSpeaker terminals

These push terminals are for connecting the speaker to your AV Receiver with the supplied speaker cables. The supplied speaker cables are color-coded for easy identification. Simply connect each cable to the same-colored positive speaker terminal.

CSpeaker mount/bracket inserts

These threaded inserts can be used to attach the speaker either horizontally or vertically to a speaker mount or bracket.

Note:

Use commercially available 1/4" screws to attach the speaker to a speaker mount or bracket.

Speaker Stand

Follow the steps below to install each front speaker onto a speaker stand.

1 Loosen the bundled speaker cable, insert the cable into the hole of the base panel from the top, then pull the cable out and downward.

Pipe stand

Speaker cable

Base panel surface

Do not pull the speaker cable too hard, as it may break.

2 Attach the pipe stand to the base panel in the correct orientation so that the screw holes on the pipe stand and the holes in the base panel will align. Tighten the screws firmly.

Pipe stand

Screws (small, ⋅ 2) Align.

3 Guide the speaker cable along the arrow on the base panel bottom, and snap the cable into the notch on the perimeter of the base panel bottom.

Notch

6