Onkyo HTP-750 instruction manual Subwoofer SKW-750X, Setting the Subwoofer Level

Getting to know Your Speaker Package—Continued

Subwoofer (SKW-750X)

■Front

If the subwoofer is placed on a hard floor (wood, vinyl, tile, etc.) and playback is very loud, the sub- woofer's feet may damage the flooring. To prevent this, place the supplied pads

underneath the subwoofer's feet. The pads also provide a stable base for the subwoofer.

		Setting the Subwoofer Level
	1	To set the level of the subwoofer, use the OUTPUT
		LEVEL control. Set it so that bass sounds are evenly bal-
		anced with the treble sounds from the other speakers.
		Because our ears are less sensitive to very low bass
		sounds, there’s a temptation to set the level of the sub-
■ Rear		woofer too high. As a rule of thumb, set the subwoofer
		level to what you think is the optimal level, and then back
		it off slightly.

SKW-750X

MIN MAX

OUTPUT LEVEL

2 3

To AC outlet

ASTANDBY/ON indicator

Red: Subwoofer in standby mode

Blue: Subwoofer on

With the Auto Standby function, the SKW-750X automatically turns on when an input signal is detected in Standby mode. When there’s no input signal for a while, the SKW-750X automatically enters Standby mode.

BOUTPUT LEVEL control

This control is used to adjust the volume of the sub- woofer.

CLINE INPUT

This RCA input should be connected to the sub- woofer pre out on your AV receiver with supplied RCA cable.

Note:

The Auto Standby function turns the subwoofer on when the input signal exceeds a certain level. If the Auto Standby function does not work reliably, try slightly increasing or decreasing the subwoofer output level on the AV receiver.

9