Onkyo MD-105X Signal Wait function, Digital recording continued, To stop recording temporarily

Digital recording (continued)

6 Press the n button and then start playing the recording source immediately.

The MD recorder stops recording automatically when the remaining space on the MD is not enough to record the next track.

n

TRACK

DIGITAL IN 1
		L						1	2	3	4	5
		40	20	10	6	2	0	6	7	8	9	10
	TOC	R						11	12	13	14	15	15

To stop recording temporarily

Press the n button (or the g button on the remote control). To resume recording, press the n button again (or press the

sbutton on the remote control).

To stop recording

Press the e button.

To eject the MD

Press the e button and then the r EJECT button.

Note

If TOC is flashing when you press the r EJECT button or the STANDBY/ON button, it means the MD recorder is writing the recorded contents onto the MD. During this period, do not disconnect the power cord or apply strong vibrations to the MD recorder. Doing so may prevent normal recording onto the MD.

•For track numbers to be marked automatically, the signature code included in the digital signal at the beginning and ending of each track is necessary. Some equipment and broadcasts do not include this signal, and in such a case track numbers will not be marked automatically.

Signal Wait function

When "LvlSyncOn" is active and the unit receives no audio signal from the recording source for 10 seconds, the unit enters the "Signal Wait" status in which the unit waits for the audio signals from the source for approx. 20 seconds. The unit resumes recording if it receives the signals from the source within the specified period of time. Otherwise, press the n button in order to resume recording.

(Not applicable while in CD-dubbing mode.)

DIGITAL IN 1
		L						1	2	3	4	5
		40	20	10	6	2	0	6	7	8	9	10
	TOC	R						11	12	13	14	15	15

30