Using the remote controller(continued)
Inserting the remote controller batteries
1 Remove the battery compart- ment cover by pressing the tab and lifting up the cover.
2 Insert two AA (R6 or
Carefully follow the polarity diagram (positive(+) and negative
3 Replace the compartment cover.
Notes
•Do not mix new batteries with old batteries or differnt kinds of batteries.
•To avoid corrosion, remove the batteries if the remote controller is not to be used for along time.
•remove dead batteries immediately to avoid damage from corrosion.if the remote controller doesn't operate smoothly, replace both the batteries at the same time.
•The life of the batteries supplied is about six months but this Will vary depending on usage.
Using the remote controller
Point the remote controller toward the remote control sensor.
With
(supplied with
Remote control sensor
30°
30°
5m
Point the remote controller toward
•Place the unit away from strong light such as direct sunlight or inverted flourescent light which can prevent proper operation of the remote contoroller.
•Using another remote controller of the same type in the same room or using the unit near equipment which uses infrared rays may cause operational interference.
•Do not put any object such as a book on the remote contoroller. The buttons of the remote contoroller may be pressed by mistake and drain the batteries.
•Make sure the audio rack doors do not have colored glass. Placing the unit behind such doors may prevent proper remote contoroller operation.
•If there is any obstacle between the remote contoroller and the remote control sensor, the remote controller will not operate.
Before Using
9