Firmware Update for the
There are the following methods to update the firmware: via network and via USB storage. Please choose either one that suits your condition. Before you start, carefully read the update procedure.
To update the firmware, it will take 15 to 25 minutes for
Update via network
You need a wired Internet connection to update the firmware.
For the update procedure, please refer to “Updating the Firmware via Network” on page 2.
Update via USB storage
Please prepare a USB storage device such as a USB flash memory stick. You need at least 32 MB of available space to update the firmware.
For the update procedure, please refer to “Updating the Firmware via USB” on page 4.
Precautions on the USB storage device:
∙The storage media in the USB card reader may not work.
∙If the storage device has been partitioned, each section will be treated as an independent device.
∙If the USB mass storage device contains a lot of data, the AV receiver/controller may take a while to read it.
∙Operation with all USB mass storage devices including the ability to power them is not guaranteed.
∙Onkyo accepts no responsibility whatsoever for the loss or damage to data stored on a USB mass storage device when that device is used
∙with the AV receiver/controller. We recommend that you back up your important music files beforehand.
∙If you connect a USB hard disk drive to the USB port, we recommend that you use its AC adapter to power it.
∙USB hubs and USB devices with hub functions are not supported. Do not connect your USB mass storage device via a USB hub.
∙USB memory devices with security functions are not supported.