Onkyo PR-SC5507, TXNR1007, TXNR3007 manual Updating the Firmware via USB

Updating the Firmware via USB

TX-NR3007/5007 allow you to update firmware using a USB storage device.

*In this procedure, on-screen display may vary depending on the model.

Note:

1.Never unplug or turn off the AV receiver/controller during updating process.

2.It will take 30 to 40 minutes to update the firmware.

3.The AV receiver/controller will retain all your settings after update is finished.

Step 1:

Connect a USB storage device to your PC. If there is any data in the USB storage, remove it.

Step 2:

Download the firmware file from the Onkyo web site. The file name is as follows: ONKAVR0001_*******. zip

Extract the zip file that you have downloaded. The following three files are created: ONKAVR0001_*******. of1 ONKAVR0001_*******. of2 ONKAVR0001_*******. of3

Step 3:

Copy the extracted files to the USB storage device. Be careful not to copy the zip file.

Step 4:

Remove the USB storage device from your PC and connect it to the USB port on the AV receiver/controller. When the AV receiver/controller has two USB ports, you can use either one.

Step 5:

Make sure your AV receiver/controller and TV are turned on.

If the AV receiver/controller is in standby mode, push [ON/STANDBY] to light up the front display.

Step 6:

Select the USB input source. “Now Initializing” is displayed on the front display and then the name of the USB storage device is displayed. It will take 20 to 30 seconds to recognize the USB storage device.

Step 7:

Push [RECEIVER] followed by [SETUP] on the remote controller.

Main menu will be displayed on TV screen. Procedures thereafter can also be performed on the AV receiver/controller by using its SETUP, arrow, and ENTER buttons.

Step 8:

Go to “7. Hardware Setup” menu.

Step 9:

Go to “7-6. Firmware Update” menu.

Step 10:

Select “Via USB” and push [ENTER].