Onkyo RDA-7.1 instruction manual Front panel facilities, Power, On/Standby

Models: RDA-7.1

1 16
Download 16 pages 37.54 Kb
Page 9
Image 9
Front panel facilities

Front panel facilities

On/Standby Power

On Off

On

Standby

Seven Channel Amplifier RDA-7.1

Power

On /

Off

On/Standby

Pressing this switch connects the RDA-7.1 to the main Power outlet and the On indicator lights blue. Sound will be heard after approximately 9 seconds. If you want to operate the RDA-7.1 using a 12-volt trigger, connect to the 12V TRIGGER OUT terminal of AV controller or pre amplifier to the 12V TRIGGER IN terminal of the RDA- 7.1, and leave the Power switch of the RDA-7.1 set to On.

For example, to control the RDA-7.1 while it is connected to the RDC-7.1 AV controller, connect the 12V TRIGGER OUT E jack of the RDC-7.1 to the 12V TRIGGER IN jack of the RDA-7.1 with the supplied stereo mini-plug cable.

If a plug is connected to the 12V TRIGGER IN jack:

The signal reaches the 12V TRIGGER, the On indicator lights blue. When there is no signal at the 12V TRIGGER, the Standby indicator lights red.

The RDA-7.1 is equipped with two indicators to display its status. If both indicators are off, then the main Power switch on the front panel is turned off. If the Power switch is turned on, then one of these indicators will be lit.

On: Lights blue when Power is supplied from the AC mains Power supply, or signal is input from the 12V TRIGGER IN terminal.

Standby: Lights red when no signal is input from the 12V TRIGGER IN terminal and the RDA-7.1 is in the Standby state.

Note:

If the Power switch is pressed and neither indicator lights, check that the Power cord is properly connected and that a fuse has not blown. If the indictors still do not light, turn off the RDA-7.1, disconnect the Power cord, and contact an Onkyo service station or representative.

If the On indicator lights blue and the Standby indicator flashes red, the protection circuitry of the RDA-7.1 has activated. The protection circuitry activates if a problem such as a speaker cable shorting or the temperature of the RDA-7.1 rising excessively occurs. Turn off the RDA- 7.1, remove the cause of the problem, and then turn the RDA-7.1 back on. If the problem is still not solved, turn off the RDA-7.1, disconnect the power cord, and contact an Onkyo service station or representative.

9

Page 9
Image 9
Onkyo RDA-7.1 Front panel facilities, Power, On/Standby, If a plug is connected to the 12V TRIGGER IN jack