Rear panel facilities and connections
Caution
•Do not connect the Power cord until you have finished all other connections.
•Read the instructions that came with the other components you are connecting.
•Do not make connections to input or output jacks while the
•Always turn the volume of the AV controller down before turning on the
SURROUND BACK | SURROUND | FRONT |
| FRONT | SURROUND | SURROUND BACK |
RIGHT | RIGHT | RIGHT | CENTER | LEFT | LEFT | LEFT |
INPUT | INPUT | INPUT | INPUT | INPUT | INPUT | INPUT |
SELECT | SELECT | SELECT | SELECT | SELECT | SELECT | SELECT |
OUTPUT |
OUTPUT |
OUTPUT |
OUTPUT |
SPEAKER IMPEDANCE
4 OHMS MIN. PER EACH SPEAKER TERMINAL
FUSE | AC INLET |
OUTPUT | OUTPUT |
12V TRIGGER
INOUT
OUTPUT |
SEVEN CHANNEL AMPLIFIER
MODEL NO.
Precaution for connection
This unit comprises 7 independent power amplifiers, each being capable of reproducing the same quality sound through its channel. Note that you should connect an input source and a speaker to each channel in use. For channels that are not in use, we recommend that you do not connect any input source or speaker.
Balanced Input (XLR terminal)
Connect AV controllers or pre amplifiers with balanced outputs for
2.
1. GND
21
3
3. inverting
Connector ground terminal: Chassis grounded
The pin assignments for this terminal are given above. This pin assignment conforms to the standard adopted by the Audio Engineering Society. Refer to the instruction manual supplied with the AV controller and verify that its output terminal is compatible with the pin assignments for this terminal. If it does not, wire it so that the output pins connect with the proper input pins.
Input terminal
1. Connecting the input terminal
Match the pins and insert the terminal until you hear a “click.” Ensure that it is secure by gently pulling it.
2. Disconnecting the input terminal
Pull out the connection cord while holding down the lever.
Push
Note:
•When using this balanced connection for a specific channel between the AV controller and
•Do not connect anything to the
Unbalanced Input (single end RCA input)
Connect AV controllers or pre amplifiers with single- ended outputs for
Note:
•When using this
•Do not connect anything to the balanced input jack.
INPUT SELECT /
This switch is located between the balanced input and
10