4 Press the MEMORY button.
MEMORY
The clock will start operating.
Tip
Switching between the 24 hour and 12 hour display settings:
1.Press the TIMER button repeatedly to display “24H/12H.”
2.Press the ENTER button.
3.Use the UP or DOWN † button to select 24H (24 hour display) or 12H (12 hour display).
4.Press the ENTER button to confirm the setting.
Note
•To use the number buttons instead of the UP or DOWN † button to set the desired day or the week and time, select the
•The ACCUCLOCK function is disabled if you set the clock manually. If you wish to enable the ACCUCLOCK function, refer to the following section.
Clock Call function
You can execute the Clock Call function only by using the remote controller that is supplied with
1 Press the CLOCK button to display the time, press again to cancel the time display.
CLOCK
Note
If the time has not been set, “ADJUST” will flash on the display.
Enabling the ACCUCLOCK function
If you have set the clock manually (see page 14), the ACCUCLOCK function is automatically disabled. To enable this function, follow the steps below:
|
| Before | |
1 Press the TIMER button repeatedly | |||
| |||
until “ADJUST” is selected on the |
| ||
display, then press the MEMORY | Using | ||
button. | |||
| |||
TIMER |
| ||
MEMORY | Connections | |
“MANUAL” appears on the display. | ||
| ||
2 Press the PRESET or ® button |
| |
until “AUTO” appears, then press |
| |
the MEMORY button. |
| |
PRESET |
| |
MEMORY | Operation | |
| ||
“- | Other | |
appear on the display. | ||
Information | ||
3 Press the MEMORY button. | ||
| ||
ACCUCLOCK will become active whenever the |
| |
|
15