Receiving stations
STANDBY/ON | BAND | MEMORY | ||
|
|
| †TUNING | |
|
|
|
|
|
|
|
|
|
|
| FM STEREO TUNER |
|
|
|
|
|
| PRESET | |
|
| BAND | TIMER MEMORY FM MODE | |
CLEAR
STANDBY/ ON
TUNING
DISPLAY CHARACTER
ACCUCLOCK
DISPLAY
Tuning the radio
Make sure that the input selector on the amplifier has been set to TUNER.
1 Press the STANDBY/ON button.
STANDBY/ ON
Display Options:
When you are listening to radio broadcasts, the display usually shows the radio frequency of the selected station. You can, however, change to the current time or character information for the selected station. To do so, press the DISPLAY button repeatedly until the desired indication appears.
For more information on how to enter character information, see “Naming a preset station” on page 19.
The display changes from clock to frequency | Using Auto Memory | |
(or character) indication. | ||
|
2 Select FM or AM using the BAND button. (only for U.S. and Canadian models)
BAND
Use the TUNING †or button to change the frequency.
TUNING
This function enables you to store the frequencies into memory automatically, without having to go through and store each frequency manually.
1 Hold down the MEMORY button for a few seconds. “AUTO” will start flashing on the display. Keep holding down the button for a few more seconds to start the Auto Memory function.
MEMORY
AUTO
MEMORY
The indoor antenna should be installed on a wall or other surface in the position which gives the best reception. For more information on how to install the antenna, refer to page 10, 11.
Note
AM reception is available on the U.S. and Canadian models.
16
Hold down
The frequencies are scanned from low to high. Up to 20 FM and 10 AM stations (U.S. and Canadian models) and 20 FM stations
Note
All stations previously stored in memory will be replaced with new Auto Memory stations.