Onkyo Rear Panel, Getting to Know the T-4555P-Continued, AXM ANTENNA C-HDXMtuner board only

T-4555P_En.book Page 10 Wednesday, August 9, 2006 3:42 PM

Getting to Know the T-4555P—Continued

Rear Panel

■C-HDXM tuner board installed

1 2 3 4 5 6 7 8 9

■C-AMFM tuner board installed

2 3 4 5 6 7 8 9

For detailed information, refer to the pages in parentheses.

AXM ANTENNA (C-HDXM tuner board only) (21)

This jack is for connecting the XM Mini-Tuner (not supplied).

BFM 75Ω ANTENNA (14)

This jack is for connecting an indoor or outdoor FM antenna. An indoor FM antenna is supplied with each tuner board.

CAM ANTENNA (14)

These push terminals are for connecting an AM loop antenna or outdoor AM antenna. An AM loop antenna is supplied with each tuner board.

DAUDIO OUTPUT (16)

Using the supplied audio cable, connect these out- put jacks to an analog audio input on your amp.

E REMOTE CONTROL (17)

These two identical (Remote Interactive) jacks

can be connected to the jacks on your other Onkyo components for interactive control. To use , the T-4555P must be connected with an cable and an audio cable.

F12V TRIGGER IN/OUT (17)

The 12V TRIGGER OUT jack can be connected to the 12-volt trigger input on another component, so that when the T-4555P is turned on, the other com- ponent turns on as well.

GIR IN/OUT (18)

A commercially available IR receiver can be con- nected to the IR IN jack, allowing you to control the T-4555P while you’re in another room, or control it when it’s out of sight, for example, installed in a cabinet.

A commercially available IR emitter can be con- nected to the IR OUT jack to pass IR (infrared) remote control signals through to other components.

HRS232

This port is for connecting the T-4555P to home automation equipment and external controllers.

IPower cord (6)

The power cord should be connected to a suitable wall outlet.

The 12V TRIGGER IN jack can be connected to the 12-volt trigger output on another component, so that when the other component is turned on, the T-4555P turns on as well.

10

See pages 16–18 for connection information.