Onkyo TX-DS474 appendix Selecting a sound source, When Multi channel input is selected as a source

Selecting a sound source

1

POWER	SLEEP	DIMMER	SUR	MULTI-CH
			MODE	INPUT
	INPUT SELECTOR
DVD	TAPE	TUNER	PHONO	C D
VIDEO-1 VIDEO-2			TUNER
		GROUP	PRESET
C D		DVD
DISC				MULTI-CH
				INPUT
TAPE		CH SEL	TEST
			TONE
		LEVEL	MUTING	VOLUME

2

LEFT			CENTER		RIGHT
SUBWOOFER				L-SUR	R-SUR
POWER			SUR	MULTI-CH	CH SEL
	SLEEP	DIMMER MODE		INPUT	TEST
DVD	TAPE	TUNER	PHONO	C D
	INPUT SELECTOR				TONE
VIDEO-1 VIDEO-2			TUNER
		GROUP	PRESET
C D		DVD
DISC
TAPE		CH SEL	TEST
			TONE
		LEVEL	MUTING	VOLUME	LEVEL

When Multi channel input is selected as a source

Follow the steps below to adjust the level of each speaker if you have selected MULTI-CH INPUT.

1.Press MULTI-CH INPUT button on the remote controller. You cannot select any Surround mode.

2.Press the CH SEL button to select the desired speakers.

3.Use the LEVEL π/† button to change the volume level of the speakers.

You can adjust the volume level of each speaker individually. Adjust the level while listening to the sound in the listening position.

You can adjust the level of the front, center, and surround speak- ers in the range between –12dB and +12dB.

You can adjust the subwoofer level in the range between –30dB and +12dB.

DVD Player		TX-DS474
		DIGITAL 2
		(COAXIAL)
		DIGITAL 1
		(OPTICAL)
1	DVD
DVD ANLG	DVD DIG1	DVD DIG2
2
	DIGITAL 1

Switching between digital and analog inputs

Either a digital or analog device can be connected to the digital connector. Follow the steps below to select digital or analog according to the type of the connected device.

Assume that you have connected a DVD player to the DIGITAL 1 connector.

1.Press the Input Selector button (DVD) repeatedly to select “DVD DIG1.”

Pressing the DVD button repeatedly changes the display as shown in the illustration on the left.

ANLG : Analog input

DIG1 : Digital input (DIGITAL 1 (OPTICAL))

DIG2 : Digital input (DIGITAL 2 (COAXIAL))

If an analog device is connected, press the Input Selector button to select “ANLG.”

You can switch between digital and analog for the DVD, VIDEO- 1, 2, and CD input sources.

To cancel a digital input assignment, press the corresponding input selector button until “ANLG” is displayed.

Even when the digital inputs are used, the analog connecting cables must be left in place. Otherwise, the audio output from TAPE OUT and VIDEO-2 will not work. (See page 7.)

Warning:

•Do not play CD-ROM discs that contain computer data as they may damage the speakers when the sound is amplified by the receiver.

17