Onkyo TX-DS575x Using the Test Tone function on the main unit, Note, Test Tone, 3. CH SEL button, 24.. TEST button, 2. VOL q/u buttons, 1. MODE AUDIO button

Speaker setup

1. MODE AUDIO button

3. CH SEL button

2. VOL q/u buttons

24.. TEST button

3. LEVEL +/– buttons

Test Tone

Use the remote controller and produce the test tone to adjust the level of the connected speakers.

1.Press the MODE AUDIO button.

2.Press the TEST button.

Press the VOL q button repeatedly to gradually raise the volume to an appropriate level.

Each speaker produces the test tone (pink noise) in the follow- ing order:

LEFT (Front L ch)	CENTER	RIGHT (Front R ch)

	(Center ch)
		R-SURROUND
SUBWOOFER	L-SURROUND

No sound will be output from the speakers for which the CON- FIG parameters is set to NO or NONE.

3.To adjust the level of each speaker, press the CH SEL button to select a speaker and press the LEVEL +/– buttons to raise or lower the level.

The test tone should sound at the same level when you hear it in your listening position. You can adjust the level in the range between –12dB and +12dB.

If the speaker level is set to +1dB or higher, the maximum level indicated on the display will change if you raise the volume level. Refer to “About volume (VOLUME)” on page 20 for more information.

4.Press the TEST button to complete adjustment.

Note

•The Test Tone function is not available when SPEAKERS B is selected, when the headphones are connected, or when MULTI- CH INPUT is selected.

Using the Test Tone function on the main unit

1.Press the SP/SYS SETUP button.

2.Press the ENTER/SCAN or ENTER button while “SPEAKER SETUP” appears on the display.

3.Press the SP/SYS SETUP button twice while “CONFIG SETUP” appears on the display.

4.Press the ENTER/SCAN or ENTER button while “LEVEL SETUP” appears on the display. Each speaker produces the test tone in the order described above.