Onkyo TX-DS575x Video equipment connections, Notes:, Digital audio connections, •A yellow connector (marked V) is used for video connection

Video equipment connections

•On each pair of input jacks, a red connector (marked R) corresponds to the right channel, and a white connector (marked L) to the left channel.

•A yellow connector (marked V) is used for video connection.

•Please refer to the instruction manual of each component when making any con- nections.

Audio connection cable	L
L (Left)
R (Right)	R
Video connection cable
V (Video)	V

DVD Player		Digital audio connections
		This receiver has a powerful digital signal
AUDIO OUTPUT	DIGITAL COAXIAL OUTPUT	processor for use with DVD players, DAT
VIDEO OUTPUT	DIGITAL OPTICAL OUTPUT	decks, and CD players. The digital inputs,
S-VIDEO OUTPUT		COAXIAL 1, 2 and OPTICAL1, 2 can be
		assigned to individual input selector buttons,
		so when an input selector button is pressed, the
		assigned digital input is used instead of the
		corresponding analog input. (See page 18.)

						DIGITAL INPUT
						COAXIAL 2	FRONT	SURROUND
	WARNING	AVIS					SPEAKERS B	SPEAKERS
	RISK OF ELECTRIC SHOCK	RISQUE DE CHOC ELECTRIQUE
	DO NOT OPEN	NE PAS OUVRIR		L	L	COAXIAL 1
	R	L	V	S	FRONT		L	L
ANTENNA
	DVD		IN		SPEAKERS
					A	OPTICAL 2
AM				R	R
	VIDEO 3		IN			OPTICAL 1	R	R
	VIDEO 2		IN
FM					CENTER			AC OUTLETS
					SPEAKER
75			IN			REMOTE CONTROL		AC 230V 50Hz SWITCHED
								TOTAL 100W MAX.
	VIDEO 1
GND			OUT	FRONT
				R	L
	(PLAY)		MONITOR	SURROUND
	IN	V
			OUT	S	L
				R		AV RECEIVER
L	TAPE					MODEL NO. TX-DS575X
	OUT		SUBWOOFER		SUB
			PRE OUT	CENTER
	(REC)				WOOFER
R
PHONO	R	L		MULTI CH INPUT
	CD

: signal flow

AUDIO OUT	S-VIDEO OUT	S-VIDEO IN
		VIDEO IN	S-VIDEO OUT
AUDIO IN	S-VIDEO IN
			VIDEO OUT
VIDEO OUT	VIDEO IN
			AUDIO OUT
		Monitor TV
Video Cassette Recorder			VDP Player

Notes:

•When using a playback-only VCR, connect it to VIDEO 2 or VIDEO 3. If you connect it to VIDEO 1, you need to make only the out- put connections.

•This receiver can be used with only a monitor TV equipped with a video input jack.

•Interference may be caused between the TV and this receiver. If this interference occurs, place the receiver and the TV as far apart as possible. We do not recommend the use of a common TV/FM antenna (see antenna section).

•A DVD or other component equipped with a digital output can be connected to this receiver. The digital connection must be used in conjunction with an analog connection, because if the analog cable is disconnected, the audio output from TAPE OUT (REC) and VIDEO 1 OUT will not work.

•A signal input from the S-video connector will be routed to the S-video out, and the signal input from the video connector will be routed to the video out.

•Refer to the instruction manual for the devices you wish to connect for information on whether you need to connect only the S-video connector, or both S-video connector and video connector.

•Remove the protective cap attached to the DIGITAL INPUT (OPTICAL) jack before making the connection. When this jack is not used, replace the protective cap.

7