Onkyo TX-DS595 appendix Changing the audio mode, Temporarily changing the speaker output levels

Enjoying music or videos with the TX-DS595

Changing the audio mode

Press the AUDIO SELECTOR button on the front panel (or the AUDIO button on the remote controller) to change the audio mode. Each time the button is pressed, the mode changes from “AUTO” → “MULTICH” → “ANALOG” and back to “AUTO.” The “AUTO” audio mode is recommended for normal circumstances.

AUTO (automatic detection): With this setting, the TX-DS595 automatically detects whether the input signal is digital or analog. When a digital signal is not input, then the analog signal is played.

MULTICH: Select this setting to play back the input from the component connected to the MULTI CHANNEL INPUT port. This setting is effective when the Multichannel setting in the Audio Setup is set to “YES.”

ANALOG: Select this setting to play back the input from a source component connected to an analog audio input jacks. With this setting, even if a digital signal is input from the same component, only the analog signal will be output.

Temporarily changing the speaker output levels

To change the individual speaker volumes temporarily, follow the procedure given below. Each channel can be set between –12 to +12 decibels. Note that the calibration settings will return to the original settings when the TX-DS595 is put in standby.

1.	Press the CH LEVEL button and	CH LEVEL
	select the desired speaker.
2.	Turn the jog dial to adjust the	DSP/MODE ADJ
	volume level.

PUSH TO ENTER

When using the remote controller:

1. Press the RCVR MODE button.

2. Press the CH SEL button and select the desired speaker.

3. Press the LEVEL or button to adjust the volume level.

Notes:

•You cannot select a speaker if the CONFIG parameter of the speaker is set to NO or NONE.

•If the speaker level is set to +1 dB or higher, the maximum level indicated on the display will change if you raise the volume level.

•When you press the TEST button after you set the level, the current level will be used as the value set via the test tone.

Enjoying the multichannel input

Before starting operations, first make sure that the multichannel connection is properly made and that the Multichannel setting of the Input Setup → Audio Setup is set to “YES” (see page 29).

1.Press the input source button for the component with multichannel output connected to the MULTI CHANNEL INPUT on the rear of the TX-DS595.

2.Select “MULTICH” using the AUDIO SELECTOR button on the front panel (AUDIO button on the remote controller).

TX-DS595 Remote controller

AUDIO

SELECTOR

3.Turn on the connected component and start playing the desired media.

4.If necessary, adjust the output level of each speaker as desired (see “Temporarily changing the speaker output levels” on this page).

Adjust the speaker output levels so that you can hear the same sound level from each speaker at the listening position. For the front right, front left, center, surround right, and surround left speakers, the output levels can be adjusted between –12 to +12 decibels. The subwoofer can be adjusted between –30 to +12 decibels.

5.Adjust the volume with the MASTER VOLUME dial or

the VOL buttons on the remote controller.

Using the tone control:

To make the BASS and TREBLE dials work for multichannel sources, you must first set the tone control to “ON.”

1.Turn the tone control on by pressing either the jog dial on the TX-DS595 or the DIRECT button on the remote controller.

DSP/MODE ADJ

DIRECT

2

PUSH TO ENTER

When pressed only once, the current setting appears, so press twice to change the setting.

2. Adjust the tone using the BASS and TREBLE dials.

BASSTREBLE

Notes:

•Adjusting the volume level of each speaker for the MULTI CH INPUT source does not affect the speaker level adjusted by the listening position.

•If the speaker level is set to +1 dB or higher, the maximum level indicated on the display will change if you raise the volume level.

27