Onkyo TX-NR818 instruction manual En-38

1	Turn on the AV receiver and the connected TV.
	On the TV, select the input to which the AV receiver
	is connected.
2	Set the speaker setup microphone at the Main

Listening Position a, and connect it to the SETUP

MIC jack.

SETUP MIC jack

Speaker setup microphone

The speaker setting menu appears.

Note

•The on-screen menus appear only on a TV that is connected to HDMI OUT MAIN. If your TV is connected to other video outputs, use the AV receiver’s display when changing settings.

3 When you’ve finished making the settings, press

ENTER.

MultEQ XT32: Auto Setup
	AUDYSSEY
Speakers Type(Front)	Normal
Powered Zone 2	No
Powered Zone 3	No
Preout to External Amplifier	No
Subwoofer	Yes

Perform the “Speaker Setup” according to your speaker configuration:

–Speakers Type (Front) (➔ page 59)

–Powered Zone 2 (➔ page 59)

–Powered Zone 3 (➔ page 59)

–Preout to External Amplifier (➔ page 59)

–Subwoofer (➔ page 60)

If you use a powered subwoofer(s), go to step 4. If not, go to step 5.

If “Speakers Type (Front)” is set to “Digital

Crossover”, a confirmation screen appears. Select

“Next (2-7. Digital Processing Crossover Network)” to display the screen for Digital Processing Crossover Network (➔ page 63). Continue with the settings.

4 Adjust the subwoofer volume level to 75 dB, and then press ENTER.

Test tones are played through the subwoofer. Use the volume control on the subwoofer.

Note

•If your subwoofer does not have a volume control, disregard the displayed level and press ENTER to proceed to the next step.

•If you set the subwoofer’s volume control to its maximum and the level displayed is lower than 75 dB, leave the subwoofer’s volume control at its maximum and press ENTER to proceed to the next step.

5 Use q/wto select “Audyssey Quick Start” or “Audyssey MultEQ XT32 Full Calibration”, and then press ENTER.

6 Press ENTER.

Audyssey MultEQ® XT32 Room Correction and Speaker Setup starts.

Test tones are played through each speaker as Audyssey MultEQ XT32 Room Correction and Speaker Setup runs. This process takes a few minutes. Please refrain from talking during measurements and do not stand between speakers and the microphone.

Do not disconnect the speaker setup microphone during Audyssey MultEQ XT32 Room Correction and Speaker Setup, unless you want to cancel the setup. If you select “Audyssey Quick Start”, you will go to step 9.

7 Place the speaker setup microphone at the next position, and then press ENTER.

Audyssey MultEQ XT32 performs more measurements. This takes a few minutes.

En-38

	Turning On & Basic Operations
8	When prompted, repeat step 7.
9	Use q/wto select an option, and then press ENTER.

MultEQ XT32: Auto Setup
	AUDYSSEY
	-- Review Speaker Configuration --
Subwoofer	Yes
Front	40Hz
Center	40Hz
Surround	100Hz
Front Wide	None
Front High	100Hz
Surround Back	120Hz
Surround Back Ch	2ch
Save
Cancel

The options are:

`Save:

Save the calculated settings and exit

Audyssey MultEQ XT32 Room Correction and Speaker Setup.

`Cancel:

Cancel Audyssey MultEQ XT32 Room

Correction and Speaker Setup.

Tip

•You can view the calculated settings for the speaker configuration, speaker distances, and speaker levels by using e/r.

To be continued