Onkyo TX-NR818 Controlling Other Components, En-84, Preprogrammed Remote Control Codes

Controlling Other

Components

You can use the AV receiver’s remote controller to control your other AV components. This section explains how to enter the remote control code for a component that you want to control: DVD, TV, CD, etc.

See “Learning Commands” for learning commands directly from another component’s remote controller (➔ page 89).

See “Using Normal Macros” for programming ACTIVITIES to perform a sequence of remote control actions (➔ page 90).

Preprogrammed Remote Control Codes

The following REMOTE MODE buttons are preprogrammed with remote control codes for controlling the components listed. You do not need to enter a remote control code to control these components.

For details on controlling these components, see the indicated pages.

BD/DVD Onkyo Blu-ray Disc player (➔ page 87) TV/CD Onkyo CD player (➔ page 86)

STB/DVR Apple TV

Looking up for Remote Control Codes 8

You can look up for an appropriate remote control code from the on-screen menu.

9

You need to connect your TV to the HDMI output

(HDMI OUT MAIN) to make the following on-screen setting.

1	Press RECEIVER followed by HOME.
2	Use e/rto select “Setup”, and then press ENTER.
3	Use q/wto select “Remote Controller Setup”, and
	then press ENTER.
4	Use q/wto select “Remote Mode Setup”, and then
	press ENTER.
5	Use q/wto select a remote mode, and then press
	ENTER.
	The menu of category selection appears.
6	Use q/wto select a category, and then press
	ENTER.
	The keyboard screen for brand name input appears.
7	Use q/w/e/rto select a character, and then press
	ENTER.

Repeat this step for the first three characters of the brand name.

When you have entered the 3rd character, select “Search” and press ENTER.

A list of brand names is retrieved.

If the desired brand name is not found:

Use rto select “Not Listed”, and then press

ENTER.

The keyboard screen for brand name input appears.

Controlling Other Components

Use q/wto select a brand, and then press ENTER.

A remote control code with its instructions are displayed. Follow the procedure.

If you can control the component, use q/wto select “OK”, and then press ENTER.

The on-screen menu returns to the “Remote Mode Setup” front screen.

If you cannot control the component, use q/wto select “Try Next Code” and press ENTER.

The next code is displayed.

En-84