Onkyo TX-SR505E, TX-SR8550 Controlling Other Components-Continued, Resetting REMOTE MODE Buttons

Controlling Other Components—Continued

Remote Control Codes for Onkyo Components Connected via

Onkyo components that are connected via are con- trolled by pointing the remote controller at the AV

Resetting REMOTE MODE Buttons

You can reset a REMOTE MODE button to its default remote control code.

receiver, not the component. This allows you to control components that are out of view, in a rack, for example.

1	Make sure the Onkyo component is con-
	nected with an	cable and an analog
	audio cable (RCA).
	See page 33 for details.
2	Enter the appropriate remote control code

1

REMOTE MODE

DVD

M D/CDR

CD

DOCK

T V

VCR

While holding down the REMOTE MODE button that you want to reset, press the [L NIGHT] button for 3 seconds.

The REMOTE MODE button lights up.

for the [DVD] or [CD] REMOTE MODE but-

ton.

[DVD] REMOTE MODE button 1612: Onkyo DVD player with

[CD/MD/CDR/DOCK] REMOTE MODE button 1327: Onkyo CD player with

1808: Onkyo MD recorder with

1322: Onkyo CD recorder with

1993: Onkyo RI Dock with

See the previous page for how to enter remote control codes.

3 Press the [DVD] or [CD] REMOTE MODE button, point the remote controller at the AV receiver, and operate the component.

If you want to control an Onkyo component by pointing the remote controller directly at it, or you want to control

an Onkyo component that’s not connected via , use the following remote control codes:

• [DVD] REMOTE MODE button

0627: Onkyo DVD player without (default)

•[CD/MD/CDR/DOCK] REMOTE MODE button

1817: Onkyo CD player without (default)

0868: Onkyo MD recorder without

1323: Onkyo CD recorder without

2990: Onkyo RI Dock without

Note:

If you connect an -capable Onkyo MD recorder, CD recorder, or RI Dock component to the TAPE IN/OUT or CBL/SAT jacks, for remote operation to work properly, you must set the Input Display to MD, CDR, or DOCK (see page 39).

CABLE

SAT

L NIGHT

2		Press the REMOTE MODE button
	REMOTE MODE	again.
	DVD The REMOTE MODE button flashes
	M D/CDR	twice, indicating that it’s been reset.
	CD
	DOCK
	TV	The [DVD] and [CD] REMOTE
		MODE buttons are preprogrammed
	VCR	with remote control codes for control-
	CABLE	ling Onkyo DVD players and CD play-
	SAT	ers respectively. When these buttons
		are reset, the preprogrammed code is
		restored.

Resetting the Remote Controller

You can reset the remote controller to its default settings.

1 RECEIVER	While holding down the
	[RECEIVER] REMOTE MODE but-
	ton, press the [L NIGHT] button
	for 3 seconds.
L NIGHT	The [RECEIVER] button lights up.

2	Press the [RECEIVER] REMOTE
RECEIVER	MODE button again.
	The [RECEIVER] button flashes twice,

indicating that it’s been reset.

63