InstaPrevue

These settings apply to “InstaPrevue” of the Home menu (page 40) and specify the preview display of HDMI video streams.

Sub Window

`Multi:

Displays preview thumbnails all at once.

`Single:

Displays preview thumbnails one-by-one. With this setting, you can set the number of preview thumbnails displayed.

Position

(with “Sub Window” set to “Multi”)

`Top, Bottom, Left, Right

(with “Sub Window” set to “Single”)

`UpperL, UpperR, LowerL, LowerR

With this setting, you can set the position of preview thumbnails on the TV screen.

Note

Depending on video signals, the picture may not be properly rendered on the preview thumbnails of InstaPrevue.

11. Network Setup

This section explains how to configure the AV receiver’s network settings manually.

After modifying the network settings, you must confirm the changes by executing “Save”.

If your router’s DHCP server is enabled, you don’t need to change any of these settings, as the AV receiver is set to use DHCP to configure itself automatically by default (i.e., DHCP is set to “Enable”). If, however, your router’s DHCP server is disabled (you’re for example using static IP), you’ll need to configure these settings yourself, in which case, a knowledge of Ethernet networking is essential.

What’s DHCP?

DHCP (Dynamic Host Configuration Protocol) is used by routers, computers, the AV receiver, and other devices to automatically configure themselves on a network.

What’s DNS?

The DNS (Domain Name System) translates domain

names into IP addresses. For example, when you enter a domain name such as www.onkyousa.com in

your Web browser, before accessing the site, your browser uses DNS to translate this into an IP address, in this case 63.148.251.142.

MAC Address

This is the AV receiver’s MAC (Media Access Control) address. This address cannot be changed.

Advanced Operations

DHCP

`Enable

`Disable

This setting determines whether or not the AV receiver uses DHCP to automatically configure its IP Address, Subnet Mask, Gateway, and DNS Server settings.

Note

If you select “Disable”, you must configure the “IP Address”, “Subnet Mask”, “Gateway”, and “DNS Server” settings yourself.

IP Address

`Class A:

10.0.0.0” to “10.255.255.255

`Class B:

172.16.0.0” to “172.31.255.255

`Class C:

192.168.0.0” to “192.168.255.255

Enter a static IP address provided by your Internet Service Provider (ISP).

Most routers use Class C IP addresses.

Subnet Mask

Enter the subnet mask address provided by your ISP (typically 255.255.255.0).

Gateway

Enter the gateway address provided by your ISP.

DNS Server

Enter the DNS server address provided by your ISP.

Proxy URL

To use a Web proxy, enter its URL here.

Proxy Port

If you’re using a Web proxy, enter a proxy port number here.

En-54

Operating procedure (page 44)

Page 54
Image 54
Onkyo TXNR525 instruction manual En-54, Network Setup, Dhcp