Connecting Onkyo RI Components

1

Make sure that each Onkyo component is

 

connected with an analog audio cable

 

(connection H in the hookup examples)

 

(page 14).

2

Make the uconnection (see the illustration).

3

If you’re using an RI Dock, or cassette tape

 

deck, change the Input Display (page 39).

With u(Remote Interactive), you can use the following special functions:

System On/Auto Power On

When you start playback on a component

connected via u, while the AV receiver is on

standby, the AV receiver will automatically turn on

and select that component as the input source.

Direct Change

When playback is started on a component

connected via u, the AV receiver automatically

e.g., cassette tape deck

RI Dock

Note

R L ANALOG AUDIO OUT

R L ANALOG AUDIO OUT

Connections

Using Headphones

1 Connect a pair of stereo headphones with a standard plug (1/4 inch or ø 6.3 mm) to the PHONES jack.

While the headphones plug is inserted in the PHONES jack, =indicator lights.

Note

Always turn down the volume before connecting your headphones.

While the headphones plug is inserted in the PHONES jack, the speakers are turned off. (The Zone 2 speakers are not turned off.)

When you connect a pair of headphones, the listening mode is set to Stereo, unless it’s already set to Stereo, Mono, Direct, or Pure Audio (European, Australian and Asian models).

If you connect an iPod or iPhone to the USB port on the AV receiver, no sound will be output from the headphones jack.

selects that component as the input source.

Remote Control

You can use the AV receiver’s remote controller to

control your other u-capable Onkyo components,

pointing the remote controller at the AV receiver’s

remote control sensor instead of the component.

You must enter the appropriate remote control code

first (page 58).

Use only ucables for uconnections. ucables are supplied with Onkyo components.

Some components have two ujacks. You can connect either one to the AV receiver. The other jack is for connecting additional u-capable components.

Connect only Onkyo components to ujacks. Connecting other manufacturer’s components may cause a malfunction.

Some components may not support all ufunctions. Refer to the manuals supplied with your Onkyo components.

While Zone 2 is on, the System On/Auto Power On and Direct Change ufunctions do not work.

En-19

Page 19
Image 19
Onkyo TXNR525 instruction manual En-19, Connecting Onkyo RI Components, Using Headphones