Manual No. | NFT 2100 CCD Fixed Mount Barcode |
Scanner |
|
33. No read error messages.
The scanner can be programmed to transmit an error message when no barcode is read. The unit must be in trigger mode, then, the error message will be sent at the end of a trigger time out. 2 types of messages can be sent. The first type will indicate that no label was present or that nothing was in front of the scanner. The second type will indicated that a barcode was present but could not be decoded.
To program an error message, scan the appropriate command below then scan up to 4 direct input characters. To remove the error message, scan the appropriate command below but do not scan any direct input characters.
33. Programming No read Error Messages
Computer | Function | |
Command | /Description | |
(ZZ) | START/END | |
Programming Menu | ||
| ||
|
| |
TH | Program Error message for No | |
label present. | ||
| ||
|
| |
TI | Program Error message for label | |
present but not decodable. | ||
| ||
|
|
34. Good Read LED Operation
Computer | Function | |
Command | /Description | |
(ZZ) | START/END | |
Programming Menu | ||
| ||
|
| |
T4 | Good read LED | |
disabled after decode | ||
| ||
|
| |
T5 | Good read LED ON after | |
decode for .20 seconds | ||
| ||
|
| |
T6 | Good read LED ON after | |
decode for .40 seconds | ||
| ||
|
| |
T7 | Good read LED ON after | |
decode for .80 seconds | ||
| ||
|
|
Bar Code
Command
[[
UI UJ
Bar Code
Command
[[
U5
U6
U7
U8
%
Page 63
