28
SELECTING THE SIGNAL TO RECORD
You can select the signal to record — from the
IN FROM ANT jack or an audio/video source —
in either of these ways.
• Repeatedly press INPUT until the desired
input source appears — LI NE (LI NE 1
or LINE 2 on the Model 62) for an audio/
video source, or a channel number for
broadcast signals.
• Repeatedly press CH s or CH t to set the
VCR to the desired broadcast channel or to
one channel higher than the highest chan-
nel number (or one channel lower than the
lowest channel number) for an audio/video
source.
Note: (Model 62 only) Select LINE 1 for re-
cording signals from the back AUDIO IN 1/VID-
EO IN 1 jacks, or LINE 2 for recording signals
from the front AV2 jacks.
RECEIVING/RECORDING STEREO/SAP BROADCASTS (MODEL 62 ONLY)
The Model 62 has three channels for audio re-
cording — two (left and right) stereo channel s
on the Hi-Fi track, and one monaural channel
on the standard track.
Press DISP/ENT to display the audio programs
available on the broadcast you are currently
tuned to. STEREO, SAP, and MONO appear.
Parenthesis appear around each type of audio
signal that is not available. For example, if a
station broadcasts mono (monaural) and SAP
signals, (STEREO), SAP, and MONO appear.
The arrow mark on the right of the audio mode
display indicates the current audio mode. To
select the audio mode when the broadcast has
a stereo or SAP signal, press SAP/Hi-Fi so the
arrow mark points to the desired mode.
IMMEDIATE RECORDING

Recording a Program

as YouWatch It

Follow these steps to record a program as you
watch it. If you know how long the program is,
you can set how long the VCR records so it
stops recording automatically.
Note: If you are watching the program on a TV/
monitor that is connected to the VCR’s AUDIO/
VIDEO OUT jacks, set the TV/monitor to the vid-
eo mode and skip Steps 2 and 3.
1. Turn on the VCR and the TV.
2. Set the TV’s tuner to the same channel as
3-CH-4 on the back of the VCR.
3. Press TV/VCR until VCR appears.
4. Load a blank cassette, or one that you
want to record over, into the VCR.
5. Repeatedly press SPEED on the remote
control until the desired recording speed
(SP, LP, or EP) appears.
6. Select the signal to record (see “Selecting
the Signal to Record”).
7. (Model 62 only) Set the audio recording
mode to the desired setting. See “Receiv-
ing/Recording Stereo/SAP Broadcasts
(Model 62 Only”).
8. Press REC/TIME. The VCR starts to record
and the following appears on the TV
screen:
TO SET SPEC
I
F
I
C REC T
I
ME
PLEASE PUSH REC KEY

REC 02

16-549.fm Page 28 Tue sday, July 20, 1999 5:04 PM