Optimus S700 user manual Troubleshooting, 124, Display, Settings and Power Supply

Troubleshooting

Technical Notes

124

If the camera fails to function as expected, check the list of common problems below before consulting your retailer or Nikon-authorized service representative. Refer to the page numbers in the right-most column for more information.

Display, Settings and Power Supply

Problem		Cause/Solution	A
Monitor is blank	•	Camera is off.	20
	•	Battery is exhausted.	20
	• Standby mode for saving power: press the		21, 25
		shutter-release button halfway.
	• When flash lamp blinks red, wait until flash		29
		has charged.
	• Camera and computer are connected via		69
		audio/video USB cable.
	• Camera and TV are connected via audio/video		67
		USB cable.
	• Time lapse or interval timer photography in		–
		progress.
Monitor is hard to read	•	Adjust monitor brightness.	106
	• Monitor is dirty. Clean monitor.		119
	• Monitor has dimmed to save power. Monitor		21
		brightens when controls are used.
Camera turns off without	•	Battery is low.	20
warning	• Camera has turned off automatically to save		111
	•	power.
		Battery is cold.	118
Date and time of recording are	• Pictures recorded before clock was set, and		16
not correct		“Date not set” indicator blinks during shooting,
		will have time stamp of “00/00/0000 00:00”;
		movies and voice recordings will be dated “01/
		09/2007 00:00.”
	• Check camera clock regularly against more		103
		accurate timepieces and reset as required.
No indicators displayed in	[Hide info] is selected for [Photo info].		106
monitor	Select [Show info].
[Date imprint] not available	Camera clock has not been set.		16,
			103
Date not appearing on pictures	Date does not appear on movies or on pictures		35, 38,
even when [Date imprint] is	shot using d, l, por when [Continuous] is set		40, 55,
enabled	to [Continuous] or [BSS].		86
Camera settings reset	Backup battery is exhausted; all settings were		104
	restored to their default values.