Optimus STAV-3590 owner manual Using the Remote Control

Using the Remote Control

Follow these steps to train the STAV-3590 remote control.

1.Place both controls 1–2 inches apart with the windows facing each other, as shown.

2.Press LEARN on the STAV-3590’s remote control. The TRANSMIT/ LEARN indicator flashes.

3.Select the AUDIO∙VCR/TV switch position. Set the switch to the position that best matches the function — to AUDIO for a CD player or tape deck or to VCR/TV for a VCR or television.

4.Within 1 minute, press the STAV-3590’s remote button you want to train with a pointed object, such as the tip of a pen. The TRANSMIT/LEARN indi- cator lights steadily.

5.Within 1 minute, press and hold the other device’s remote control button you want the STAV-3590 to learn. The TRANSMIT/ LEARN indicator flashes.

If TRANSMIT/LEARN flashes twice, the signal might be too weak. Place the remote controls closer together and try again.

If TRANSMIT/LEARN flashes four times and the remote control exits the learning mode, the remote control’s memory is full. Programming errors can fill memory. For example, fluorescent light, direct sunlight, the two remote controls being too far apart, or a low battery might cause this error. Repeat the procedure.

6.Repeat Steps 4 and 5 to teach additional commands.

7.To exit the teaching mode, press LEARN or wait 1 minute.

26