Optimus STAV-3590 Using Advanced Sound Options, Sound Mode Adjustments Remote Control Only

Using Advanced Sound Options

Sound Mode Adjustments (Remote Control Only)

Notes:

•If you do not use a center speaker, the monaural signals are only reproduced if you select PHANTOM.

•You cannot select PHANTOM in the Dolby 3CH Logic Sound mode.

Center Mode Setting

The center mode setting affects the center channel’s bass signals. It operates only when you select the Dolby Pro-Logic Surround or Dolby 3CH Logic mode. Slide AUDIO∙VCR/TV on the remote control to AUDIO. Each time you press CEN- TER MODE on the remote control, the setting changes, and the receiver’s corre- sponding indicator lights: NORMAL - WIDE - PHANTOM for Dolby Pro-Logic Surround; NORMAL - WIDE for Dolby 3CH Logic.

NORMAL— Select this mode if you use a small center speaker. The front left and right speakers play the center-channel bass sounds.

WIDE— Select this mode if you use a medium or large center speaker. The cen - ter speaker plays the center-channel bass sounds.

PHANTOM— Select this mode if you have no center speaker. All center-channel sound comes from the front left and right speakers.

Test Tone

The test tone feature provides a test tone that lets you balance the signal levels between all your speakers. See “Center Level” and “Rear Level.”

To activate the test tone, select one of the surround sound modes then slide AUDIO∙VCR/TV to VCR/TV and press TEST TONE. The receiver sounds a 2-sec- ond tone from the front left, center, front right, and rear speakers, in sequence. The center test tone sounds only when you select the Dolby Pro-Logic Surround or Dolby 3 CH Logic Sound mode.

In the Dolby 3CH Logic Sound mode, the receiver sounds a 2-second tone from the left, center, and right speakers, in sequence.

Press TEST TONE again to turn off this feature.

Notes:

•Use the VOLUME control to adjust the overall sound level.

•Set the center mode to a selection other than PHANTOM before adjusting the center level.

Center Level

Slide AUDIO∙VCR/TV to AUDIO. Then press – CENTER + to adjust the center speaker sound level while in the Dolby Pro-Logic Surround or Dolby 3CH Logic mode.

Rear Level

Slide AUDIO∙VCR/TV to VCR/TV. Then press – REAR + to set the rear speakers’ sound level while in the Dolby Pro-Logic Surround or Simulated Surround mode.

Note: For Dolby Pro-Logic Surround, the delay is preset to 20 mS.

Delay Time

In the Simulated Surround and Dolby Pro-Logic Surround modes, the receiver slightly delays the sound going to the rear speakers. You can change the delay time from 15 to 30 milliseconds (ms) in 5 ms steps. Adjust this for the best sur- round effect.

Slide AUDIO∙VCR/TV to VCR/TV. Then press and hold DELAY TIME to change the delay time. The receiver displays the selected time.

21