User’s Manual
Setup
1. Power up the sled and set LENS IN position
Slide the lens into the middle of the sled before powering up. Plug the power adaptor into an AC outlet, then into the back of the unit as illustrated. Using the remote, press the “lens in” button. The lens sled will slowly position itself into the factory default LENS IN position. The edge of the adaptor plate will land about a
If the bracket is not in front of the projector lens, you will need to change the setting. Simply press the LENS OUT button on the remote, and wait for the bracket to move in front of the projector lens. Press and hold the LENS OUT button again for 5 seconds. The sled will confirm the new setting by moving the bracket away from the projector lens to the new LENS OUT location. The edge of the adaptor plate will land about a
Rear Panel View
+9V DC In
+12V Trigger Out
+12V Trigger In
Remote IR Sensor In
OFF | ON |
LENS OUT | LENS IN |
PANEL OFF | PANEL ON |
SLOW | FAST |
2. Verify centering
Press LENS IN and see where the lens stops. If needed, make small adjustments (+ or – a quarter- inch) to the lens bracket after disconnecting the power, by loosening the screws and sliding the bracket to the left or right as
needed to achieve centering.
Reconnect the power and check the centering. The optical sensors will stop the edge of the lens adaptor plate approximately a half- inch from the housing on either side of the sled. You can use this gap on the motor or the pulley side for
Projector Lens
For more information, please visit our website at: | User’s Manual | 8 | |
http://www.OptomaUSA.com | |||
|
|
