Installation
Powering On/Off the Projector
Powering On the Projector
1.Remove the lens cap.
2.Securely connect the power cord and signal cable. When con- nected, the Power LED will turn red.
3.Turn on the lamp by pressing “POWER” button on the back of the
projector or pressing “ ” button on the remote control. The Power
LED will flash blue.
The startup screen will display in approximately 30 seconds. The first time you use the projector, you can select your preferred lan- guage from quick menu after the startup screen display.
4.Turn on your source that you want to display on the screen (com- puter, notebook, video player, etc). The projector will detect the source automatically and will display on the screen. If not, push menu button and go to “SETUP”. Make sure that the “Source Lock” has been set to “Off”.
If you connected multiple sources at the same time, press the “SOURCE” button or direct source keys on the remote control to switch between inputs.
or
NOTE
POWER
Turn on the projector first and then select the signal sources.
2 Power/Standby
1 Lens Cap
English 16
