Oreck 2000 Guide D’Utilisation, Comprend, Avertissements de sécurité Garantie Mode d’emploi, 9000

E N G L I S H

Bulb Replacement

WARNING: Unplug cord from electrical outlet before servicing.

fig. 23 Remove lamp housing by removing two (2) screws in the top of the lamp housing. Pull burned out bulb from holder and replace with new bulb. Use only Oreck replacement parts. Replace lamp housing by replacing two screws in the top of the lamp housing.

Stuffing or Blockage

IMPORTANT: On plush and new carpets, stuffing may occur inside the the intake tube and the lower tube assembly. This is due to excessive fuzz and loose cuttings in the carpet. Stuffing could occur for the first few cleanings until all the loose material is removed. Due to the high efficiency of the cleaner, many older carpets will cause stuffing when the cleaner is first used on them. If your vacuum cleaner does not pick up properly, or makes unusual noise and the outer bag does not fluff up or balloon open, follow these steps:

WARNING: Unplug cord from electrical outlet before servicing.

fig. 24 Check for blockage at the mouth of the intake opening. If there is blockage, remove it with long-nose pliers, a screwdriver or wire coat hanger. If you can not reach the blockage, remove baseplate (fig. 25).

fig. 26 If the blockage is not at the base, remove lower tube. Unhook retainer spring, releasing bottom of bag.

Twist lower collar counterclockwise to slide up. Pull tube out of base.

fig. 27 2000 Series: If set screw is present, loosen set screw in lower collar.

fig. 28 9000 Series: Pull rubber collar over plastic tabs on fan housing, press metal button to release tube. Twist lower tube and pull apart.

fig. 29 Check for blockage. If blockage is in the tube, remove with a coat hanger.

fig. 30 If tube is not blocked, look into fan housing. Remove debris

with long-nose pliers, a screwdriver or coat hanger.

fig. 31 To reassemble, check O-ring on tube, and replace if damaged. Vacuum will not operate properly without the tube O-ring. Slide O-ring to approximately 2" from base of tube. Replace tube by first lining up slot at base of tube with inner tab inside fan housing. Then reinsert tube and push down until the tube is seated. Make sure O-ring is in place against fan housing opening. Replace and tighten collar until collar locking tabs are locked in place.

fig. 28 9000 Series: Place tube in fan housing opening, turn tube until buttons snap into button holes. Slide collars in position, over plastic tabs on fan housing. Make sure plastic tabs are inserted in collar holes.

fig. 32 Make sure collar is not cross threaded on housing. Reattach bag spring (fig. 26).

fig. 33 Many times blockage occurs due to a full dust bag causing dirt to

back down the air flow system. When that happens, the blockage will be at the top of the system, starting in the area where the dust bag connects to the connector assembly.

NOTE: If the above actions do not correct the problem, contact an Oreck authorized service center or call the customer service center.

U.S.: 1-800-989-3535 Canada: 1-888-676-7325

S I M P LY A M A Z I N G ®

GUIDE D’UTILISATION

F R A N Ç A I S

9000

2000

3000

4000

VIDES DE SÉRIE

ASPIRATEUR VERTICAL RAPIDE

A VEC SYSTÉME DE NETTOYAGE

®

•IMPORTANT•CONSERVEZ CE FASCICULE

Comprend:

Avertissements de sécurité

Garantie

Mode d’emploi

Guide de dépannage

Accessoires

6