Oreck XL2000RS, XL2000RH warranty Assembly, Operating Instructions

			E	N		G	L	I	S	H
	Assembly							2		Upper	With ON/OFF switch facing
										Handle	the front of the unit, slide
										Connector	upper handle section over
											matching section of the
To assist you in identifying										Assembly
											connector assembly. Place
components of your vacuum,				1							brace against handle and
the parts have been numbered			9			11					connection assembly aligning
as follows:											the holes. Insert short screw
				12
											into top hole and long screw
1	Handle section, upper										into the bottom hole then
											tighten firmly until handle is
2	Tube, lower							3			no longer loose.
	5		4	13							Attach cord to cord clip by
3	Power head
				2							pressing cord above and
4	Outer bag					6					below clip ensuring the cord
											is fully rested in clip.
5	Paper filter dust bag		7
				14
6	Power cord	8	10
7	Retaining spring		3
8	Bag tension bar		10						Operating Instructions
9	Zip fastener		9			11
								To Operate
					1
10	On/off switch			12				Make sure disposable paper filter dust bag is in place. DO NOT
								operate the cleaner without a paper filter dust bag. Plug the
11	Cord hook							power cord into an electrical outlet and press the ON (l) - OFF
								(O) switch on Helping Handle Assembly, or on top of base for
	5			13				Straight Handle Models when ready to operate.
12	Plastic loop/	4						General Information
	cable clamp
								The performance of your new cleaner greatly depends upon care
13	Connector assembly							and maintenance. The instructions in this manual will guide you in
				2			6	performing basic care and maintenance. To obtain the most
								satisfying years of service read the instructions and keep them
14	Fan housing							handy for future reference.
		8	7	14		15		Operating Recommendations
15	Cord assembly							This new ORECK XL High-Speed Upright is one of the finest,
								fastest, and strongest units in its class. You’ll love the way it
								cleans, gets under things, and it’s SO lightweight and easy to
		3						use.
								The following are a few simple suggestions regarding its
								operation:

1

Before assembling appliance, remove two screws from the connector assembly. Remove cardboard insert by pulling upward.

1.When inserting a new disposable paper filter dust bag— FIRST PUFF OUT and OPEN THE BAG.

2.When the disposable filter dust bag is full, REPLACE IT.

3.If at any time the machine does not pick up properly or makes an unusual noise, STOP OPERATION and service.

4.Although your upright will pick up pins, paper clips, and other small objects, it is recommended that these be removed from the floor before you vacuum. Failure to do so may result in permanent damage to the motor suction fan and its housing.

5.WARNING: Do not use your vacuum cleaner on damp or wet surfaces. This will cause damage to the vacuum cleaner and is dangerous to the user. Damage caused by use on wet or damp surfaces is not covered under warranty.

6.REPLACE THE BELT EVERY 6 MONTHS.

4