E N G L I S H
7.Change the disposable filter dust bag at least once a
8.brushDO NOTcould damage the cord.
9.Use caution when vacuuming over area rug edges & fringe.
Disposable Paper Filter Dust Bags
Disposable paper filter dust bags play a very important role in the efficiency of your ORECK vacuum cleaner. The purpose of the filter bag is to trap dirt, but at the same time it must be porous enough to allow air to pass through. If the filter bag becomes clogged, no air can pass through the cleaner and cleaning cannot take place, regardless of the cleaner’s power. Increase the CLEANING POWER of your cleaner by changing the bag often.
To keep your cleaner operating at maximum efficiency, change the dust bag frequently. DO NOT FILL ABOVE THE LINE INDICATED ON THE DUST BAG.
Be sure the disposable paper filter dust bag is installed properly.
All paper dust bags are not the same. Your ORECK disposable dust bags have been designed to be used with the ORECK cleaner. Using bags other than genuine ORECK disposable bags will affect the cleaning ability of your cleaner and could cause damage to it.
The Belt
The belt on your vacuum cleaner controls the speed of the revolving brush and is very important for the effective operation of the cleaner. If the belt becomes stretched or cut, it will cause the revolving brush to stop completely or slow down. See instructions in the manual for replacing belt.
An extra belt is stored in the baseplate of your cleaner. When buying replacement belts, use ONLY ORECK genuine belts. Belts other than ORECK belts will not operate the revolving brush correctly and may create undue stress which will cause damage to the motor and brush bearings. Using belts other than ORECK belts will void the warranty.
Lubrication
The vacuum cleaner motor bearings are factory lubricated and sealed. Further lubrication is not required.
General Cleaner Care
At least once a month, check for and remove excessive lint, string
or hair from revolving brush.
Wipe the outside of the cleaner
with a damp cloth. Also, clean
the connector deflector assembly
area, base of cleaner and fan
housing area. If there is dust in
the outer bag, vacuum it or
shake it out.
A little preventative maintenance will keep your cleaner looking new and will ensure continued cleaning effectiveness.
Use floor and floor finish manufacturer’s recommended methods of cleaning. The metal strip on the base of the cleaner could be damaged if used on concrete or abrasive surfaces, and, therefore, cause damage to wood floors, soft (vinyl, asphalt tile, etc.) floor surfaces and polished floor finishes. The roller brush may also scuff very soft finishes. Do not operate the unit while in the upright and locked position. Do not let the unit run while in any one stationary position for any period of time. Keep the unit moving while in operation.
5
Celoc® Hypo-Allergenic Filter System
The CELOC SMMS outer bag of your vacuum cleaner is high filtration medical material designed to filter the smallest of dust particles. It is important the inside of the outer bag be cleaned. Turning the outer bag inside out, vacuum the inside of the outer bag or hand wash with warm water and then let the bag air dry. For best results, theTheCELOCCELOCSMMSlayeredouterdisposablebag shouldinnerbe
dustreplacedbag oncemust abeyearreplaced. once a month even if it is . Change it more often if it is used in extremely dirty areasnot full. Increase the cleaning power of your vacuum by changing the
bag often.
To Replace Filter
Dust Bag
| WARNING: Unplug cord from |
| electrical outlet before servicing. |
| BAG INSTALLATION: |
| 1. Hook bottom of bag collar |
| opening under lip “B” of |
A | connector assembly. Pull up |
| on bag collar and snap over |
B | lip “A” of connector. |
| 2. Press on edges of bag collar |
| to insure bag is completely |
| installed. |
IMPORTANT: Check to make sure bag collar is behind lips “A” and “B”.
If it is not, dust will leak into outer bag. When filter bag is in place, close outer bag with zipper fastener.
