![](/images/new-backgrounds/1114559/11455911x1.webp)
OPERATION OF THE LOG SPLITTER
ONLY operate the log splitter from the operator zone as shown in the diagram. The operator has the safest and most efficient access to the control valve and the beam in this location. Operating the log splitter in another location can result in serious injury or death.
TOP VIEW
OPERATOR
ZONE
ALWAYS block the wheels to prevent movement of the log splitter while in operation.
KNOW how to stop the log splitter and disengage the controls before operating it.
NEVER place hands or feet between the log and splitting wedge during forward or reverse stroke as this could result in serious injury or death.
NEVER straddle or step over the log splitter during operation.
NEVER reach or bend over the log splitter to pick up a log.
NEVER try to split two logs on top of each other.
NEVER try to cross split a log.
NEVER attempt to load the log splitter when the ram or wedge is in motion.
NEVER use your foot, a rope or any extension device to operate the control lever on the valve. Only use hand.
NEVER move the log splitter while the engine is running. Shut off the engine if you are leaving the log splitter, even for a short period of time.
NEVER touch the muffler and other hot areas of the engine during operation. Wait until the engine cools down. ALWAYS be careful when moving or lifting the log splitter. Get assistance if it feels too heavy to move by yourself.
GENERAL REPAIR
NEVER operate your log splitter when it is in poor mechanical condition or in need of repair.
NEVER alter your log splitter in any manner. Such alterations may cause your log splitter to be unsafe and will void the warranty.
NEVER tamper with the engine to run it at excessive speeds. The maximum engine speed is preset by the manufacturer and is within safety limits. Refer to the engine owner’s manual for your particular log splitter.
Page 4