EN
4.RESET hole
5.C�ANNEL switch
GETTING STARTED
SET UP REMOTE SENSOR
. Slide open the battery door.
2.Insert battery, matching the polarities (+ /
3.Select channel then press RESET.
4.Close the battery door.
TIP Use alkaline batteries for longer usage and consumer grade lithium batteries in temperatures below freezing.
SET UP MAIN UNIT
NOTE Set up the remote sensor before installing the main unit.
. Remove the battery compartment cover.
2.Insert the batteries, matching the polarities.
3.Press RESET after each battery change.
NOTE Batteries should not be exposed to excessive heat such as sunshine or fire.
SET UP STAND
TIP By placing the unit on the stand, the main unit is able to run on the additional batteries located in the stand.
. Remove the battery compartment cover.
2. Insert the batteries, matching the polarities.
DATA TRANSMISSION
SENSOR
To search for a sensor:
Press and hold | + | together. |
For best results:
•Place the sensor within 30 m of the main unit.
•Position the sensor so that it faces the main unit, minimizing obstructions such as doors, walls and furniture.
•Place the sensor out of direct sunlight and moisture.
•Place the sensor in a location with a clear view to the sky, away from metallic / electronic objects.
•Position the sensor close to the main unit during cold winter months as
The remote sensor reception icon will show the following status:
|
| ICON | DESCRIPTION | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Main unit is searching for |
|
|
|
|
|
|
| sensor(s). |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| A channel has been found. |
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| The sensor cannot be found. |
|
|
|
|
|
|
|
|
NOTE The main unit will search only for already registered sensor or new sensor reset within the last 30 minutes. If unit failed to synchronise with remote sensor, reset the sensor or try selecting a different channel (and press RESET) before manually forcing another search.
4
