Oregon Scientific WMR200A user manual Getting Started Set Up Base Station, Insert Batteries

To set up the Rain Gauge:

1 2

1.Remove screws and slide the cover off in an upwards motion.

2.Insert the batteries (2 x UM-3 / AA), matching the polarities (+ / -). Press RESET after each battery change.

EN

Install the base station batteries (4 x UM-3 / AA) matching the polarity (+ / -). Press RESET after each battery change.

NOTE Do not use rechargeable batteries. It is recommended that you use alkaline batteries with this product for longer performance.

3

3. Remove the fibre tape.

To ensure a level plane:

Put a few drops of water on the cross at the base of the funnel to check the horizontal level.

1

3 2

4

Water will pool to the center of the cross when the rain gauge is level.

If water remains on 1-4, the gauge is not horizontal.

If necessary, adjust the level using the screw.

NOTE For best results, ensure the base is horizontal to allow maximum drainage of any collected rain.

GETTING STARTED

SET UP BASE STATION

NOTE Install batteries matching the polarities (+ / -) in the remote sensor before installing the base station.

For continuous use, install the AC adapter. The batteries are for back-up use only.

NOTE Please make sure the socket-outlet is installed near the equipment and is easily accessible.

INSERT BATTERIES

1.Remove the battery compartment.

2.Insert the batteries, matching the polarities (+ / -).

3.Press RESET after each battery change.

LOCATION	MEANING
Weather forecast area	Main unit batteries low
Rainfall / UV / Wind / Outdoor	Sensor batteries low
temperature / humidity area

SENSOR DATA TRANSMISSION

To search for a sensor:

1.Select desired area to activate.

2.Press and hold CH and MEM.

3. icons will flash for 5 minutes.

NOTE Unit will search only for already registered sensors or new sensors reset within last 30 minutes. To register a new sensor, reset sensor prior to search.

The sensor reception icon in the remote sensor area shows the status:

ICON	DESCRIPTION
	Main unit is searching for sensor(s)
	A channel has been found
	Sensor 1 data received

The sensor cannot be found.

TIP The transmission range may vary depending on many factors. You may need to experiment with various locations to get the best results.

CLOCK

CLOCK RECEPTION

This product is designed to synchronize its clock automatically with a clock signal.

WMR200:

Slide switch to EU / UK to select the desired signal.

•EU: DCF-77 signal: within 1500km (932 miles) of Frankfurt, Germany.

•UK: MSF-60 signal: within 1500km (932 miles) of Anthorn, England.

WMR200A:

WWVB-60 signal: within 3200km (2000 miles) of Fort Collins Colorado. Manually set clock to select time zone (Pacific, Mountain, Central or Eastern).

indicates the status of the clock reception signal.

ICON	MEANING
	Time is synchronized
	Receiving signal is strong
	Time is not synchronized
	Receiving signal is weak

7