Oricom C1000 1.8 GHz Recall, Phone Key, Basic Steps For Installation, Charging the POD

Models: C1000 1.8 GHz

1 21
Download 21 pages 53.72 Kb
Page 6
Image 6
Phone Key

Phone Key

Key Function

Key

Phone Book

 

 

 

Service

 

 

 

Recall

Recall

Redial / Program

 

 

 

Clear / Number

 

 

 

Up

 

 

 

Down

 

 

 

Phone On/Off

 

 

 

Mute

 

 

 

Ringer On/Off

 

Dial Tone

 

 

 

Pause

 

 

 

11

Basic Steps For Installation

1.Set up the base and POD on a flat, stable surface.

2.Connect the output plug of the base adaptor to the Recallsocket on the bottom of the base unit and the adaptor to the main wall outlet. The power LED on the base should become steadily lit.

3.Connect one end of the telephone line to the Basic Steps For Installationsocket on the bottom of the base unit and the other end to the wall phone socket.

4.Remove the battery cover on the base of the pod and insert the battery pack (supplied with the unit), observing the correct orientation of the plug with the connector. Relocate the battery compartment door.

5.Connect the output plug of the POD adaptor to the Charging the POD socket on the top of the POD unit and the power adaptor to power socket. Allow the battery to charge for at least 15 hours before first use.

To Ensure Better Performance CAUTION

Use only the power adaptors supplied with this product. Incorrect adaptor polarity or voltage can seriously damage the unit.

For Base:

For POD:

Input: 240 VAC 50 Hz

Input: 240 VAC 50 Hz

Output: 7 VDC 400 mA

Output: 12 VDC 500 mA

Polarity: Center positive

Polarity: Center positive

Manual background CAUTION

RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. Refer to the original type supplied with this telephone. Ni-MH batteries must be disposed of in accordance with applicable waste disposal regulations.

Charging the POD

If the battery icon flashes or the LED’s on the POD flashes RED periodically during phone mode, the battery pack needs recharging. Connect the POD to the AC adaptor plugged to the main wall outlet to start charging.

Note: POD shall take 30 seconds to power up when the adaptor is connected to a flat battery pack.

To Ensure Better Performance

1.Locate the conference telephone in a quiet environment.

2.Position the POD within 30 metres of the base unit.

3.Do not use the POD with the other phone in a single room.

4.Do not move the POD during a call.

12

Page 6
Image 6
Oricom C1000 1.8 GHz Recall, Phone Key, Basic Steps For Installation, Charging the POD, To Ensure Better Performance