Getting Started
Installation
Cordless Phone
1.Connect the mains adaptor (supplied) to the socket on the back of the base unit and to the wall mains supply.
2.Connect the telephone cord to the phone socket on the back of the base unit and into the wall phone socket.
3.Insert 2 rechargeable Ni-MH AAA
1.2V 800mAh batteries (included), 
observing the correct polarity, into the battery compartment on the
handset. Slide the battery door fi rmly into place.
4.Place the handset on the charging cradle and charge the batteries for a full 15 hours before using it for the first time.
Corded Phone
1.Connect the mains adaptor (supplied) to the socket on the back of the base unit and to the wall mains supply.
2.Connect the telephone cord to the phone socket on the back of the base unit and into the wall phone socket.
Select your country
After the phone is fully charged you will need to select your country. The phone will display Welcome. Press [ 
]. Scroll [ 
] or [ 
] to select Australia or New Zealand. Press [ 
] again to confi rm.
Note:
It may take some time for the cordless handset to power up, and it may get warm during initial charge. This is normal.
It is good practice to put the cordless handset on the charging cradle when it is not in use to ensure that the handset is always fully charged.
IMPORTANT:
DO YOU HAVE BROADBAND/ADSL?
If you do, you must connect an in line fi lter (not supplied) between the telephone socket and your Pro900 base to ensure that your broadband and Pro900 will work properly. If you do not install the fi lter you will experience interference on the Pro900 and your Broadband may suffer dropouts. Please refer to the user guide of the in line fi lter for installation.
2
