PICTURE CONTROL ADJUSTMENTS

The picture settings have been factory adjusted under optimum signal recep- tion. However, conditions may not be the same in your area. After tuning in the unit, allow it to warm up for a few min- utes. If the picture is not to your liking, make the following adjustments using the remote control.

Preparation

Press TV/VCR to select TV/VCR mode.

1 To adjust the picture, press MENU.

Press or to select the TV SETUP mode, then press

ENTER.

TIMER REC SET AUTO REPEAT CHANNEL SETUP TV SETUP SYSTEM SETUP

SELECT :

ENTER : ENTER

EXIT : MENU

OFF

2 Press or to select the PICTURE mode, then press

ENTER.

3 Press ENTER until your desired PICTURE mode appears e.g. brightness, contrast, colour, sharpness. Then pressorto adjust the level of the PICTURE. (See below for details.)

TV SETUP

ON/OFF TIMER SET PICTURE

NICAMAUTO

SELECT :

ENTER : ENTER

EXIT : MENU

BRIGHTNESS

0

 

 

 

 

 

 

 

 

 

 

 

 

 

SET

:

 

 

 

 

 

 

 

EXIT : MENU

RESET

 

: CANCEL

 

 

NEXT

 

: ENTER

 

 

NOTE:

To resume the normal picture adjust- ment, press CANCEL, while in the picture mode menu.

4 After finishing the adjustment, press MENU 3 times to return to normal TV screen.

Each time you press ENTER the picture adjustment Screen changes as follows.

BRIGHTNESS

Press ENTER until “BRIGHTNESS” appears on the screen, then press or to adjust the brightness. When is pressed, the darker portions of the picture become lighter.

CONTRAST

Press ENTER until “CONTRAST” appears on the screen, then press or to adjust the contrast. Pressing improves the contrast and enhances the colour. Picture looks sharper in the daytime by increasing the contrast level and sharper at night by lowering the contrast level.

COLOUR

Press ENTER until “COLOUR” appears on the screen, then press or to adjust the intensity of the colours. This should be set to where the colours appear normal in intensity and brilliance.

SHARPNESS

Press ENTER until “SHARPNESS” appears on the screen, then press or to adjust the sharpness.

In weak reception areas, the picture may be more pleasing when the SHARPNESS is set at a lower level.

NOTES:

 

The picture settings can only be adjusted by using or

 

and ENTER when they are displayed on the screen.

 

Press MENU 3 times to return to normal TV screen.

 

The On-screen display will disappear about one minute

 

after finishing an adjustment.

17

 

Page 19
Image 19
Orion 21FVD manual Picture Control Adjustments, Brightness, Contrast, Colour, Sharpness