Orion 9843 instruction manual Appendix B Cleaning the Optics, Cleaning Lenses, Cleaning Mirrors

Figure 9. To center the secondary mirror under the focuser, hold the secondary in place with your fingers while adjusting the primary screw with a Phillips head screwdriver. Do not touch the mirror’s surface.

Figure 10. Adjust the tilt of the secondary mirror by loosening or tightening the three alignment screws with a small Phillips head screwdriver.

will need to make slight corrections to the telescope’s position in order to account for the sky’s apparent motion.

Appendix B:

Cleaning the Optics

Cleaning Lenses

Any quality optical lens cleaning tissue and optical lens clean- ing fluid specifically designed for multi-coated optics can be used to clean the exposed lenses of your eyepieces or find- erscope. Never use regular glass cleaner or cleaning fluid designed for eyeglasses

Before cleaning with fluid and tissue, blow any loose particles off the lens with a blower bulb or compressed air. Then apply some cleaning fluid to a tissue, never directly on the optics. Wipe the lens gently in a circular motion, then remove any excess fluid with a fresh lens tissue. Oily fingerprints and smudges may be removed using this method. Use caution; rubbing too hard may scratch the lens. On larger lenses, clean only a small area at a time, using a fresh lens tissue on each area. Never reuse tissues.

Cleaning Mirrors

You should not have to clean the telescope’s mirror very often; normally once every year or so. Covering the telescope with the dust cap when it is not in use will help prevent dust from accumulating on the mirrors. Improper cleaning can scratch mirror coatings, so the fewer times you have to clean the mir- rors, the better. Small specks of dust or flecks of paint have virtually no effect on the visual performance of the telescope

The large primary mirror and the elliptical secondary mirror of your telescope are front-surface aluminized and over coated with hard silicon dioxide, which prevents the aluminum from

Figure 11. Loosen one screw on the back of the optical tube one full turn and tighten the other screw “in the set” until tight to adjust the primary mirror.

oxidizing. These coatings normally last through many years of use before requiring re-coating, which is easily done.

To clean the secondary mirror, it must be removed from the telescope. Do this by holding the secondary mirror holder sta- tionary with your fingers (don’t touch the mirror itself) while unthreading the Phillips head screw in the center hub of the 3- vaned spider. Completely unthread the screw from the holder, and the holder will come loose in your fingers. Be careful not to lose the spring on the Phillips head cap screw.

Handle the mirror and its holder carefully. You do not need to remove the secondary mirror from its holder for cleaning. Follow the same procedure described below for cleaning the primary mirror.

13