STT40 / STT70
5.2.2. Cleaning or Replacing the Return Air Filter
STT40 / STT70
•Detach the screw on the housing of the return air filter and remove the housing cover.
•Remove the nut of the filter cartridge.
•Remove the filter cartridge.
•Clean the inside of the return air filter housing. Use
•Vacuuming - Try
•Cleaning with Compressed Air - Blow clean, dry compressed air up and down the pleats, blowing from the inside out. Remove loose dirt from the filter with compressed air or vaccum from the outside.
Figure 1: Air Filter Location & Disassembly
Return Air Filter
)DO NOT clean/wash filter with water!
•After each cleaning:
•Inspect the filter element. Briefly hold a light bulb behind the element and look for any fatigued paper or residual dirt. Inspect for holes and tears by looking though the filter toward a bright light. Check for damaged gaskets or dented metal parts. Do not
•Check the gasket for damage. A damaged gasket allows contaminants into the process. Replace as needed.
•
•Rethread the nut that holds the filter in place.
•Install the lid of the return air filter housing.
)Never operate the dryer without a return air filter.
Purchase order numbers for a return air filter on the STT40/70 dryer are:
when operating without return air cooler: ID 83957
when operating with return air cooler: ID 83956
Maintenance