Sterling STT70, STT40 manual

It is recommended that the dryer be Self-Optimized. The following steps should be taken to self optimize the dryer:

a.) Press and hold the “EXIT” button for at least 2 seconds.

b.) “tunE” will flash while self-optimization is in progress (can take several minutes) c.) When “tunE” stops flashing; self-optimization is completed.

d.) When self-optimization is complete press “EXIT” key once. e.) At this point the dryer is ready to run continuously.

Note: If for any reason the “FAULT” orange light goes on, please go to Chapter-4 in this operation manual for troubleshooting instructions.

(CAUTION: DO NOT TURN MAIN POWER DISCONNECT TO THE OFF POSITION WITHOUT FIRST TURNING THE BLOWER SWITCH TO THE OFF “0” POSITION. WAIT UNTIL THE BLOWER HAS TIMED OUT PRIOR TO DISCONNECTING MAIN POWER.)