Orion Car Audio 1892 1335 Messages from Outstation to Base Station, IDS IDD 51 nn tt dd ss CH

Messages from Outstation to Base Station

04	IDS IDD 50 bbbb CH	Reply to poll with bbbb = battery ADC level
		(reply to 20 command)
04	IDS IDD 51 nn tt dd ss CH	Setup status of digital input (set by bit in byte nn)
		(reply to 21 or 31):
		If tt = 0 then don’t send alarm message
		If tt = 1 then= send alarm message
		If tt = 2 and port = 00 then poll counter is used
		Dwell time dd, (1 -255)*10ms, (0 = no dwell time)
		Logic 0 in byte ss indicates a High to Low change
		Logic 1 in byte ss indicates a Low to High change
04	IDS IDD 52 nn cc llll dd ss CH	Setup status of analogue input (set by bit in byte nn)
		(reply to 22 or 32 command:
		Analogue input type: cc = 1, 20mA; cc = 2, 0 - 5V; cc = 3;
		0 - 10V
		ADC trip level ll, 1 - 1023, (0 = no trip level)
		Dwell time dd, (1 -255)*10ms, (0 = no dwell time)
		If bit 0 in byte ss = 1 then alarm sent if above trip level
		If bit 0 in byte ss = 0 then alarm sent if below trip level
04	IDS IDD 53 nn mmmm CH	Analogue output port nn ADC value mmmm
		(reply to 23 command)
04	IDS IDD 54 nn CH	Digital outputs state
		(reply to 24 command):
		Logic 0 in byte nn indicates output = Low
		Logic 1 in byte nn indicates output = High
04	IDS IDD 55 pp dd CH	Pulse count status
		(reply to 25 command)
		If pp = 1 pulse count enabled with Dwell time dd
04	IDS IDD 56 bbbb CH	Battery trip level bbbb
		(reply to 26 command)
04	IDS IDD 57 CH	Config stored in Flash
		(reply to 27 command)
04	IDS IDD 58 ffff CH	New channel ffff (1 to 400) of outstation
		(reply to 28 command)
		Channel change to occur after this acknowledge
		message
04	IDS IDD 59 bb CH	TX power set to level bb (reply to 29 command)
		Power change to occur before this acknowledge message

1892 1335 - Orion Radio Modem Operating Instructions - v1.3 / Aug 2006 33