Orion Car Audio HCCA124 Polypropylene dust cap moisture and UV resistant, Voice coil former

1	Polypropylene dust cap - moisture and UV resistant.
2	Tall, wide, balanced, NBR Foam (high density expanded polyester foam)
	surround for linear controlled long excursion using a Tri Radius symmetrical
	edge design optimized on non-linear FEA.
3	Paper cone - moisture and UV resistant.
4	Custom Cast Aluminum frame.
5	Spider ring attachment screws. Part of re-cone feature (8 hex screws)
6	aluminum voice coil former (10” uses 3” voice coil former, 12 & 15 use a 4”
	voice coil former)
7	Venting in Voice coil former. Part of the enhanced voice coil cooling system
	(forced convection)
8	11mm Steel front plate.
9	,ARGERSTACKACERAMICAMAGNETSNv OZ v OZ
10	MM 3TEELEBACK PLATEAPOLE PIECEE4 YOKE ASSEMBLY
11	1.25” vent. Part of the enhanced voice coil cooling system (forced convection
	- aluminum heat sinking - shorting rings to reduce inductive heating)..
12	Voice coil gap vents. Part of the enhanced voice coil cooling system (forced
	convection - aluminum heat sinking -shorting rings to reduce inductive
	heating).
13	Cast aluminum rear pole piece heat sink with fins and vent holes. Part of
	the enhanced voice coil cooling system (forced convection - aluminum heat
	sinking)
14	High temperature (Polyester Amide Resin Coated) Copper clad Aluminum
	voice coil wound on an aluminum former (10” uses 3” voice coil, 12 & 15 use
	a 4” voice coil) Dual 2 and 4 ohm voice coils available
15	Screen meshed areas to allow venting below spider to and keep foreign
	object out of the voice coil gap.
16	Cast aluminum top pole piece heat sink with fins and vent hole. Part of
	the enhanced voice coil cooling system (forced convection-aluminum heat
	sinking-shorting rings to reduce inductive heating).
17	Bottom flat interlaced Conex spider with stitched and looped tinsel leads
	attached.
18	Custom allen head screw terminals. A pair on each side (one pair for each
	voice coil).
19	Spider spacer and spider mounting ring assembly part of field re-cone kit
	attachment method. (eight allen head screws).
20	Top flat interlaced Conex spider.
21	Surround clamp ring, part of field re-cone kit attachment method. (eight
	allen head screws).

4 © 2008 Directed Electronics. All rights reserved.