Owner’s Manual
Specifications
Warning: if you suspect that the grounding system in your home’s electrical wiring is causing the hum problem, it is important that you do not make any changes to the wiring yourself. Only a licensed electrician should make any changes to household wiring, and they must be made in full compliance with all local building, safety and electrical codes.
Suggestion #4:
Faulty earth grounds may also cause hum in your home’s electrical system. In the past, cold water pipes were often used for the earth ground, so it is important to make sure that your ground connection is still valid and has not become loose or corroded. The cold water pipe method may no longer be valid in some locations due to requirements that the water meter be isolated from the water mains with a length of PVC pipe, thus interrupting the ground circuit. The safest, and most reliable, approach may be to provide your own ground. This can be accomplished by having a licensed electrician drive at least five feet of
Suggestion #5:
If you have hum in your video display device (bars that roll up through image at
If the hum persists after all of the above suggestions have been tried, contact the Outlaw Audio customer service department for assistance.
Specifications
Power Output | 200 watts @ 8 ohms, 20 Hz 20 kHz, <0.05% THD |
| 300 watts @ 4 ohms, 20 Hz 20 kHz, <0.05% THD |
|
|
THD Signal to Noise | 100 dB |
|
|
Trigger Input | |
|
|
Operating Mode | Class G/AB |
|
|
Input Impedance | >10K Ohms |
|
|
Gain | +27dB (1.7V sensitivity) for full output |
|
|
Input Connector | RCA Jack |
|
|
Output Connectors | |
|
|
Power Consumption | 600 watts maximum; <3 watts standby |
|
|
Weight | 18 pounds /8.165 Kg. |
|
|
Dimensions (H/W/D) | 1.5” x 17” x 11.5”/40mm x 430 mm x 330 mm |
|
|
Note: Due to our policy of continual improvement, all specifications are subject to change without notice or liability to upgrade previously shipped units to current specifications or standards
10
Outlaw Audio
