| Owner’s Manual |
| A Few Words About Hum and Noise |
Troubleshooting Guide |
|
Problem | Solutions |
|
|
Amplifier will not turn on | Master Power Switch turned off (No power light LED) |
| Turn on Master Power Switch |
|
|
Amplifier will not turn on | Remote trigger cable not properly connected |
| Verify connection of trigger cable at both ends |
|
|
Amplifier turns on, but no audio from one or more channels | Input plugs not connected to proper jack or are loose |
| Check input connections |
|
|
No audio from one or more channels | Speakers not connected properly |
| Check speaker connections at amp and speaker |
|
|
Audio levels differ | Improper settings or output levels from the processor or controller |
| Check the settings on your preamp, processor or controller |
|
|
Audio plays, then cuts off | Amplifier shorted |
| Check speaker connections for short circuit at amp and speaker |
Troubleshooting
Your Outlaw
Protection Circuitry
Your Outlaw Audio Amplifier uses advanced protection circuitry that does not require fuses. In the event that the amplifier senses a shorted speaker wire, DC voltage on an input connection or thermal overload creates a condition that could potentialy cause damage to the unit or to your speakers, it will automatically shut down.
If this should happen, first check all speaker wire connections, both at the speakers themselves and at the speaker terminals on the back of the Model 755 to make certain that none of the stands from any channel touch another channel, and that none of the strands from a "positive" terminal touch those from a "negative" terminal. Even a few stray wire strands can cause the unit to go into the protection mode.
After checking all speaker connections, turn the unit back on. If it continues to turn off, check your speakers to verify that they are operating properly. If all other potential sources of trouble check out properly, contact Outlaw Audio for further assistance and information.
Outlaw Service Information
Neither the Model 755 nor Model 770 contains any user serviceable parts. If you suspect a problem that may require service assistance, contact us at customerservice@outlawaudio.com, or by phone at
It is important that any repairs be carried out only by an authorized service agent. This will assure proper service and preserve the protection of your Limited Warranty. Keep your sales slip or receipt in a safe place with this manual so that it will be available to verify the purchase date, should you expereince a problem covered by our warranty.
A Few Words About Hum and Noise
Audible hum, or a discernable low frequency noise, is one of the most com- mon problems in audio/video systems. This hum, which may be present even when the volume is at a low level or when the power is off, is usually caused by a problem known as “ground loops”. A ground loop occurs when there is a difference in ground voltages between two or more components that are con- nected electrically. This, in turn, creates multiple current paths and causes the
The growing sophistication of home theater systems, and the increased number of components used to create these systems has dramatically increased the potential for the possibility of ground loops. While it is natural to suspect that the components in your system are the cause of the hum, in many cases the cause may be due to other conditions. In particular, cable TV connections from outside the house have become a major source of hum.
In most cases, one of the following suggestions should help you to solve a hum problem in your system. Please try these steps in the sequence shown, proceeding from one step to the next if the prior suggestion does not eliminate the problem.
Model 770/755
9
