Palsonic 5179G owner manual To preset channels Search

OPERATION

Tuning in (continued)

Use the SEARCH function if desired channels can not be preset with the ASM or if you would like to preset channels to specific position numbers one by one.

It is convenient to set the channel numbers to the same position numbers using SEARCH and SKIP functions.

To preset channels (SEARCH)

SEARCH

If ASM can not preset the desired channels, or you want to preset the desired channels one by one with the preferred channel numbers, please make use of SEARCH.

1.	Enter into PRESET menu, press the POS+/- button to
	select and highlight POS. Press the VOL+/- button to
	select a desired position number (from 0-255).
	Note: you can also press 0-9 button to select a one-digit
	position number.
	Press --/--- button and number buttons to select a two-
	digit or three-digit position number.

PRESET
POS	4
SKIP	ON
BAND	V-L
FINE	OFF
AFT
SEARCH
ASM	OFF
S-RCV

2.	Press the POS+/- button to select SEARCH. Press the
	VOL+ button to search channels from current channel
	.
	to higher channel. Press the VOL- button to search
	channels from current channel to lower channel. When
	a channel is located, the searching stops, this channel is
	then memorized with the preset position number.

Note: you can also make use of BAND selection to quicken the searching process in your desired band. Press the POS+/- button to select BAND, pressing the VOL+/- button moves the band to the next one in the sequence below.

V-L V-H UHF

PRESET

POS4

SKIPON

BANDV-L FINE

AFTOFF

SEARCH

ASM

S-RCVOFF

PRESET

POS20

SKIPOFF

BAND V-H

FINE

AFTOFF SEARCH

ASM

S-RCVOFF

3. When you want to store another channel at another position, repeat steps 1 & 2 above.

Note: After SEARCH, to exit the PRESET menu, press the RECALL button, or press PRESET button or MENU button repeatedly until OSD disappears.

8