MAX® 5100-PM BACK PANEL FEATURES
1. Circuit Breaker: | 2. Outlet Bank 3 | 3. Outlet Bank 2 | ||||
Automatically opens | Two switched, | Four isolated, switched outlets with linear filtration | ||||
when the current load | the front panel Power Button or the DC Trigger | technology (LiFT) controlled by the front panel | ||||
is greater than 15 | input. Bank 3 has a 5 second turn on delay and | Power Button or the DC Trigger input. Bank 2 will | ||||
Amps. Push to reset. | turns off immediately. The High Current outlet | turn on immediately and turn off after 10 seconds. | ||||
|
| provides power from a low impedance noise | LiFT EMI/RFI noise filtration is provided by a two- | |||
|
| filtration circuit that does not limit the current to | stage balanced Pi filter which also provides noise | |||
|
| |||||
|
| your equipment. Its output is noise isolated from all | isolation from Outlet Banks 1 and 3. | |||
|
| other outlet banks. |
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
4. Outlet Bank 1
Four
Universal TV Coaxial Jacks 3 pairs of bidirectional protection circuits optimized for satellite, cable, and antenna TV signal lines.
9. Main Power | 10. Ground Lug: | 11. Bank 1 Indicator Light | 12. Voltage Sense Trigger | 13. LAN Jacks |
Must be plugged into a | Provides a common | Normally ON, is lit when | Input | Protection circuits for 10/100 baseT |
properly wired & grounded | grounding point for | there is power present on the | 3.5mm (1/8”) mono | Ethernet lines. Incoming LAN line MUST |
equipment with separate | Bank 1 receptacles. | Connect to a remote trigger | be plugged into the LINE jack. Patch cord | |
| ground leads |
| device that uses a DC output | to the equipment MUST be plugged into |
|
|
| to trigger a startup/shutdown | the EQUIP jacks. 1 LAN jack goes to the |
|
|
| sequence. | front panel output jack. 8 wire protection, |
|
|
|
| 50V clamping. |
14. Phone Jacks
Protection circuits for standard telephone or
MAX® 5100-PM SPECIFICATIONS
General________________________________________________________________
Dimensions | 17 in. W x 12.75 in. D x 3.5 in H, (4.1 in. Including feet) |
Weight | 13.5 lbs. |
AC Power_______________________________________________________________ | |
Line Voltage | 120V, 60Hz |
Total Current Capacity | 15 A |
UL1449 Suppression Rating | 330V |
Protection Modes | |
Initial Clamping Level | 200V |
Energy Dissipation | 2310 Joules |
Peak Impulse Current | 90,000 Amps |
Catastrophic Surge Circuit | Yes |
Thermal Fusing: | Yes |
142 VAC ± 5 VAC | |
90 VAC ± 2 VAC | |
EMI/RFI Noise Filtration___________________________________________________ | |
Banks 1 & 2 | 80 db, 100 KHz – 2 MHz |
Bank 3, High Current Outlets | 60 db, 100 KHz – 2 MHz |
DC Trigger Input__________________________________________________________ | |
Jacks | 3.5mm mono |
Voltage and Polarity | 3 - 24V DC, bidirectional |
Current Requirement | 4.6 mA @3V, 58 mA @24V |
LAN Circuits_____________________________________________________________
Clamping Level | 50V |
Jacks | |
Wires Protected: | |
USB Circuit_____________________________________________________________ | |
Jacks | |
Power Delivery | 500 mA @5VDC |
Telephone Circuit________________________________________________________ | |
Yes | |
Clamping Level | 260V |
Capacitance | 30pf (approx.) |
Suppression Modes | Metallic & Longitudinal |
Connections | |
Lines Protected | |
Cable and Satellite TV Circuits______________________________________________ | |
HD 1080 i/p Ready | Yes |
Bidirectional | Yes |
Shielded | Yes |
Clamping Level | 75V |
Frequency Range | 0MHz - 2.2 GHz |
Insertion Loss | < 0.5 dB |
Connections | Female “F”, Gold Plated |
Design and specifications subject to change without notice due to product improvement.
UPC’S, QUANTITIES, WEIGHTS & MEASUREMENTS FOR ORDERING & SHIPPING
MODEL |
|
| UNIT CARTON |
|
|
|
| MASTER CARTON |
| ||||
17” x 12.75” x 3.5” |
| 13.5 lbs | 23.75” x 19.25” x 9.25” |
| 18 Lbs |
| 0 50616 00817 4 | 1 |
| 23.75” x 19.75” x 9.75” |
| 19 Lbs |
|
|
|
|
|
|
| ||||||||
4.1” H with feet |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1690 Corporate Circle, Petaluma, CA. 94954
© 2007 Panamax, Inc. Panamax, MAX, and the Panamax logo are registered US trademarks of Panamax
5 00 50616 00817 9
L587 REV A 5/07