Panamax MB1000 manual Installing Your UPS, Input, AC Power, UPS Output

Installing Your UPS

HARDWARE INSTALLATION GUIDE

1.Your new UPS may be used immediately upon receipt. However, recharging the battery for at least four hours is recom- mended to insure that the battery’s maximum charge capacity is achieved. Charge loss may occur during shipping and storage. To recharge the battery, simply leave the unit plugged into an AC outlet. The unit will charge in both the ON as well as the OFF position. If you wish to use the software, connect the enclosed USB cable to the USB port on the UPS and an open USB port on the computer.

2.With the UPS unit OFF and unplugged, plug your equipment into the unit’s rear panel AC outlets. DO NOT plug a space heater, vacuum cleaner, paper shredder or other large electrical device into the UPS. The power demands of these devices will overload and possibly damage the unit.

3.Plug the UPS into a 2 pole, 3 wire grounded receptacle (wall outlet). Make sure the wall branch outlet is protected by a fuse or circuit breaker and does not service equipment with large electrical demands (e. g. refrigerator, copier, etc.) Avoid using extension cords. If used, the extension cord must be UL or CSA Listed, minimum 14 AWG, 3-wire grounded, and rated for 15 Amps.

Specifications

Input

Voltage	85 – 137 Vac
Frequency	57 – 63 Hz

AC Power

Current Rating	12 A
Surge Protection	900 Joules
Overvoltage Shutoff, fast rise	150 ± 5 V
Overvoltage Shutoff, slow rise	132 ± 5 V
Undervoltage Shutoff	90 ± 5 V
Automatic Voltage Regulation,
Sensitive Mode Capture Range	98 – 135 V
Automatic Voltage Regulation,
Sensitive Mode Output Range	120 ± 5%
Automatic Voltage Regulation,
Standard Mode Capture Range	93 – 145 V
Automatic Voltage Regulation,
Standard Mode Output Range	120 ± 10%
Bank 1 EMI Filtration	66dB Max, 100kHz-2MHz
Bank 2 EMI Filtration	66dB Max, 100kHz-2MHz

4.Press and hold the power switch for 2 seconds to turn the UPS on. The display will say “Initializing”, followed by the normal operation screen.

5.The rear panel circuit breakers will open and power to the connected equipment will be turned OFF if an overload is detected. To correct this, turn the UPS off, unplug at least one piece of equipment, wait 10 seconds, check to make sure that the circuit breakers are reset, and turn the unit on.

6.The UPS will automatically charge the battery whenever it is plugged into an AC outlet.

7.To maintain optimal battery charge, leave the UPS plugged into an AC outlet at all times.

Note: To store your UPS for an extended period, cover it and store with the battery fully charged. Recharge the battery every three months to ensure battery life.

UPS Output

Voltage	120 ± 5 V Simulated Sine Wave
Frequency	60 Hz ± 1%
UPS Output Capacity	1000VA 600W @ 0.6pf
UPS Backup Time	3 minutes at full load
Transfer Time	< 10ms

2